In the coming era of the internet of things (IoT), wireless sensor networks that monitor, detect, and gather data will play a crucial role in advancements in public safety, human healthcare, industrial automation, and energy management. Batteries are currently the power source of choice for operating wireless network devices due to their ease of installation; however, they require periodic replacement due to capacity limitations. Within the scope of the IoT, battery maintenance of the trillion sensor nodes that may be implemented will be practically infeasible from environmental, resource, and labor cost perspectives. In considering individual self-powered sensor nodes, the idea of harvesting energy from ambient vibrations, heat, and electromagnetic waves has recently triggered noticeable research interest in the academic community. This paper gives an overview of energy harvesting materials and systems. Three main categories are presented: piezoelectric ceramics/polymers, magnetostrictive alloys, and magnetoelectric (ME) multiferroic composites. State-of-the-art harvesting materials and structures are presented with a focus on characterization, fabrication, modeling and simulation, and durability and reliability. Some perspectives and challenges for the future development of energy harvesting materials are also highlighted.

No abstract

This paper studies the energy harvesting characteristics of piezoelectric laminates consisting of barium titanate (BaTiO3) and copper (Cu) from room temperature to cryogenic/high temperatures both experimentally and numerically. First, the output voltages of the piezoelectric BaTiO3/Cu laminates were measured from room temperature to a cryogenic temperature (77 K). The output power was evaluated for various values of load resistance. The results showed that the maximum output power density is approximately 2240 nW cm−3. The output voltages of the BaTiO3/Cu laminates were also measured from room temperature to a higher temperature (333 K). To discuss the output voltages of the BaTiO3/Cu laminates due to temperature changes, phase field and finite element simulations were combined. A phase field model for grain growth was used to generate grain structures. The phase field model was then employed for BaTiO3 polycrystals, coupled with the time-dependent Ginzburg–Landau theory and the oxygen vacancies diffusion, to calculate the temperature-dependent piezoelectric coefficient and permittivity. Using these properties, the output voltages of the BaTiO3/Cu laminates from room temperature to both 77 K and 333 K were analyzed by three dimensional finite element methods, and the results are presented for several grain sizes and oxygen vacancy densities. It was found that electricity in the BaTiO3 ceramic layer is generated not only through the piezoelectric effect caused by a thermally induced bending stress but also by the temperature dependence of the BaTiO3 piezoelectric coefficient and permittivity.