Diiron diselenolato complexes have been prepared as models of the active site of [FeFe]-hydrogenases. Treatment of Fe 3 (CO) 12 with 1 equiv of 1,3-diselenocyanatopropane (1) in THF at reflux afforded the model compound Fe 2 (µ-Se 2 C 3 H 6 )(CO) 6 (2) in 68% yield. The analogous methyl-substituted complex, Fe 2 (µ-Se 2 C 3 H 5 CH 3 )(CO) 6 (3), was obtained from the reaction of Fe 3 (CO) 12 with the in situ generated compound 3-methyl-1,2-diselenolane (4). In contrast, the reaction of Fe 3 (CO) 12 with 1,3,5-triselenacyclohexane (5) produced a mixture of Fe 2 (µ 2 ,κ-Se,C-SeCH 2 SeCH 2 )(CO) 6 (6), Fe 2 [(µ-SeCH 2 ) 2 Se](CO) 6 (7), and Fe 2 (µ-Se 2 CH 2 )(CO) 6 (8). Compounds 2, 3, 6, and 7 were characterized by IR, 1 H, 13 C, and 77 Se NMR spectroscopy, mass spectrometry, elemental analysis, and X-ray single-crystal structure analysis. The He I and He II photoelectron spectra for 3 are reported, and the electronic structure is further analyzed with the aid of DFT computations. The calculated reorganization energy of the cation of 3 to the "rotated" structure, which has a semibridging carbonyl ligand, is less than that of the analogous complexes with sulfur instead of selenium. Complexes 2 and 3 have been proved to be catalysts for electrochemical reduction of protons from the weak acids pivalic and acetic acid, respectively, to give hydrogen.

In order to elucidate the influence of the bridging chalcogen atoms in hydrogenase model complexes, diiron dithiolato, diselenolato, and ditellurolato complexes have been prepared and characterized. Treatment of Fe3(CO)12 with 3,3-bis(thiocyanatomethyl)oxetane (1) or a mixture of 2-oxa-6,7-dithiaspiro[3.4]octane (2a) and 2-oxa-6,7,8-trithiaspiro[3.5]nonane (2b) in toluene at reflux afforded the model compound Fe2(μ-S2C5H8O)(CO)6 (3). The analogous diselenolato and ditellurolato complexes, Fe2(μ-Se2C5H8O)(CO)6 (4) and Fe2(μ-Te2C5H8O)(CO)6 (5), were obtained from the reaction of Fe3(CO)12 with 2-oxa-6,7-diselenaspiro[3.4]octane (6) and 2-oxa-6,7-ditelluraspiro[3.4]octane (7), respectively. Compounds 3−5 were characterized by spectroscopic techniques (NMR, IR, photoelectron spectroscopy), mass spectrometry, single-crystal X-ray analysis, and computational modeling. The electrochemical properties for the new compounds have been studied to assess their ability to catalyze electrochemical reduction of protons to give dihydrogen, and the catalytic rate is found to decrease on going from the sulfur to selenium to tellurium compounds. In the series 3−5 the reorganization energy on going to the corresponding cation decreased from 3 to 4 to 5. Spectroscopic and computational analysis suggests that the increasing size of the chalcogen atoms from S to Se to Te increases the Fe−Fe distance and decreases the ability of the complex to form the structure with a rotated Fe(CO)3 group that has a bridging carbonyl ligand and a vacant coordination site for protonation. This effect is mirrored on reduction of 3−5 in that the rotated structure with a bridging carbonyl, which creates a vacant coordination site for protonation, is disfavored on going from the S to Se to Te complexes.