We have investigated the properties of transverse sonic hydrogen jets in hightemperature supersonic crossflow at jet-to-crossflow momentum flux ratios J between 0.3 and 5.0. The crossflow was held fixed at a Mach number of 2.4, 1400 K and 40 kPa. Schlieren and OH * chemiluminescence imaging were used to investigate the global flame structure, penetration and ignition points; OH planar laser-induced fluorescence imaging over several planes was used to investigate the instantaneous reaction zone. It is found that J indirectly controls many of the combustion processes. Two regimes for low (<1) and high (>3) J are identified. At low J, the flame is lifted and stabilizes in the wake close to the wall possibly by autoignition after some partial premixing occurs; most of the heat release occurs at the wall in regions where OH occurs over broad regions. At high J, the flame is anchored at the upstream recirculation region and remains attached to the wall within the boundary layer where OH remains distributed over broad regions; a strong reacting shear layer exists where the flame is organized in thin layers. Stabilization occurs in the upstream recirculation region that forms as a consequence of the strong interaction between the bow shock, the jet and the boundary layer. In general, this interaction -which indirectly depends on J because it controls the jet penetration -dominates the fluid dynamic processes and thus stabilization. As a result, the flow field may be characterized by a flame structure characteristic of multiple interacting combustion regimes, from (non-premixed) flamelets to (partially premixed) distributed reaction zones, thus requiring a description based on a multi-regime combustion formulation.

Importance: Filtering facepiece respirators, including N95 masks, are a critical component of infection prevention in hospitals. Due to unprecedented shortages in N95 respirators, many healthcare systems have explored reprocessing of N95 respirators. Data supporting these approaches are lacking in real hospital settings. In particular, published studies have not yet reported an evaluation of multiple viruses, bacteria, and fungi along with respirator filtration and fit in a single, full-scale study. Objective: We initiated a full-scale study to evaluate different N95 FFR decontamination strategies and their impact on respirator integrity and inactivating multiple microorganisms, with experimental conditions informed by the needs and constraints of the hospital. Methods: We explored several reprocessing methods using new 3MTM 1860 N95 respirators, including dry (<10% relative humidity) and moist (62-66% relative humidity) heat (80-82 oC) in the drying cycle of industrial instrument washers, ethylene oxide (EtO), pulsed xenon UV (UV-PX), hydrogen peroxide gas plasma (HPGP), and vaporous hydrogen peroxide (VHP). Respirator samples were treated and analyzed for biological indicator inactivation using four viruses (MS2, phi6, influenza A virus, murine hepatitis virus), three bacteria (Escherichia coli, Staphylococcus aureus, Geobacillus stearothermophilus), and the fungus Aspergillus niger. The impact of different application media was also evaluated. In parallel, decontaminated respirators were evaluated for filtration integrity and fit. Results: VHP resulted in >2 log10 inactivation of all tested biological indicators. The combination of UV-PX + moist heat resulted in >2 log10 inactivation of all biological indicators except G. stearothermohphilus. Greater than 95% filtration efficiency was maintained following 2 (UV-PX + <10% relative humidity heat) or 10 (VHP) cycles of treatment, and proper fit was also preserved. UV-PX + dry heat was insufficient to inactivate all biological indicators. Although very effective at virus decontamination, HPGP resulted in decreased filtration efficiency after 3 cycles, and EtO treatment raised potential toxicity concerns. The observed inactivation of viruses with UV-PX, heat, and hydrogen peroxide treatments varied as a function of which culture media (PBS buffer or DMEM) they were deposited in. Conclusions and Relevance: High levels of biological indicator inactivation were achieved following treatment with either moist heat or VHP. These same treatments did not significantly impact mask filtration or fit. Hospitals have a variety of scalable options to safely reprocess N95 masks. Beyond value in the current Covid-19 pandemic, the broad group of microorganisms and conditions tested make these results relevant in potential future pandemic scenarios.

No abstract

Turbulent dimethyl ether (DME) jet flames provide a canonical flame geometry for studying turbulenceflame interactions in oxygenated fuels and for developing predictive models of these interactions. The development of accurate models for DME/air flames would establish a foundation for studies of more complex oxygenated fuels. We present a joint experimental and computational investigation of the velocity field and OH and CH 2 O distributions in a piloted, partially-premixed turbulent DME/air jet flame with a jet exit Reynolds number, Re D , of 29,300. The turbulent DME/air flame is analogous to the well-studied, partially-premixed methane/air jet flame, Sandia Flame D, with identical stoichiometric mixture fraction, n st = 0.35, and bulk jet exit velocity, V bulk = 45.9 m/s. Measurements include particle image velocimetry (PIV) and simultaneous CH 2 O and OH laser-induced fluorescence (LIF) imaging. Simulations are performed using a large eddy simulation combined with conditional moment closure (LES-CMC) on an intermediate size grid of 1.3 million cells. Overall, the downstream evolution of the mean and RMS profiles of velocity, OH, and CH 2 O are well predicted, with the largest discrepancies occurring for CH 2 O at x/D = 20-25. LES-CMC simulations employing two different chemical reaction mechanisms (Kaiser et al., 2000 [20] and Zhao et al., 2008 [21]) show approximately a factor of two difference in the peak CH 2 O mole fractions, whereas OH mole fractions are in good agreement between the two mechanisms. The single-shot LIF measurements of OH and CH 2 O show a wide range of separation distances between the spatial distributions of these intermediate species with gaps on the order of millimeters. The intermittency in the overlap between these species indicates that the consumption rates of formaldehyde by OH in the turbulent DME/air jet flame may be highly intermittent with significant departures from flamelet models.

No abstract