This paper is concerned with the application of automated digital photogrammetry, using 1:3000 scale photography, to complex, natural landform surfaces, of typical interest to geomorphologists. It assesses the quality of the results obtained using a relatively cheap and readily available area based stereomatching package, in terms of precision, accuracy and external reliability. Precision is investigated with reference to the confidence that can be placed in individual matches. Accuracy is evaluated using specially collected, independent datasets obtained from an area of complex topography in Glen Affric, Scotland. Data collection was stratified to areas of different surface roughness. External reliability is judged with respect to estimates of slope, a key parameter in geomorphological investigations. The results show that, whilst the effects of grid density and vegetation correction are the most important controls upon the accuracy and the external reliability of the photogrammetric results, collection parameters associated with the stereomatching process can also exert some control, particularly in areas of complex topography. It is impossible to generalize rules for choice of optimal collection parameters without careful consideration of the surface under investigation. Given that maximum grid densities are defined by the object space pixel resolution, the paper concludes that surface quality is largely governed by traditional controls upon photogrammetric data quality (camera calibration, base:distance ratio, ground control), combined with either scanning density or digital image resolution. However, over some surfaces, careful consideration has to be given to the effect of matching parameters.

This paper describes and assesses: (i) the use of a new instrument for the determination of three-dimensional flow velocities in natural rivers, the acoustic Doppler velocimeter (ADV); and (ii) a method for positioning and orienting such measurements relative to a single local coordinate system to relate flow velocity vectors with the bed and water surface. The ADV uses the Doppler shift principle to measure the velocity of small particles, assumed to be moving at velocities similar to the fluid. Velocity is resolved into three orthogonal components, and measured in a volume 5 cm below the sensor head, minimizing interference of the flow field, and allowing measurements to be made close to the bed. A simple method for positioning and orienting the instrument using digital tacheometry is described, and is used to obtain velocity measurements concurrently with measurements of both bed and water surface topography. The paper includes a preliminary field assessment of the ADV by comparing velocity profiles with those generated from Marsh McBirney electromagnetic current meters, and a full field assessment of the position and orientation methodology. These results suggest that the recommended methods in combination with an ADV are able to provide reliable mean three-dimensional velocity field information and accurate bed and surface topography.

This paper describes and assesses: (i) the use of a new instrument for the determination of three-dimensional flow velocities in natural rivers, the acoustic Doppler velocimeter (ADV); and (ii) a method for positioning and orienting such measurements relative to a single local coordinate system to relate flow velocity vectors with the bed and water surface. The ADV uses the Doppler shift principle to measure the velocity of small particles, assumed to be moving at velocities similar to the fluid. Velocity is resolved into three orthogonal components, and measured in a volume 5 cm below the sensor head, minimizing interference of the flow field, and allowing measurements to be made close to the bed. A simple method for positioning and orienting the instrument using digital tacheometry is described, and is used to obtain velocity measurements concurrently with measurements of both bed and water surface topography. The paper includes a preliminary field assessment of the ADV by comparing velocity profiles with those generated from Marsh McBirney electromagnetic current meters, and a full field assessment of the position and orientation methodology. These results suggest that the recommended methods in combination with an ADV are able to provide reliable mean three-dimensional velocity field information and accurate bed and surface topography.

No abstract

Anthraquinone is not suitable for inclusion in bait for rat control at the concentrations tested, and also presents some risk to efficacy for possum control. D-pulegone would be suitable for inclusion in bait for possums and rats, but problems related to its volatility in bait manufacture and storage would need to be overcome. Further studies should focus on an alternative secondary repellent, or on establishing the maximum anthraquinone concentration that does not reduce efficacy for rats and testing whether or not that concentration is sufficient to repel native birds from baits reliably.