Flax unidirectional (UD) fabrics and polyamide 11 (PA11) are used to create a 100% biosourced composite. The fabrication process is hot press moulding. Different configurations are studied by varying process parameters and composite constituents. Three temperature values (190 C, 200 C and 210 C) are combined with three pressure levels (35, 65 and 100 bars). In addition, two types of flax fabric (A and B) are tested and two types of PA11 (in the form of powder or film) are used. The two forms of PA11 are characterized using differential scanning calorimetry and rheological methods. Ten different composites are then manufactured. They are compared by means of tensile tests and dynamic mechanical analysis (DMA). Results are correlated with microstructural study: measurements of porosity degree and scanning electron microscopic observations are also performed. Finally, an optimum configuration is determined: the composite flax B/PA11 film manufactured with a temperature value of 210 C and using gradual levels of pressure (25 bars during 2 min, 40 bars during 2 min and 65 bars until the end of cycle). This configuration leads to a Young's modulus value of 36 GPa and a tensile strength of 174 MPa, with the highest storage modulus and the lowest damping factor values measured by DMA.
In this paper, the low-energy impact behavior of a fully biobased composite made of bio-sourced polyamide 11 resin reinforced with flax fibers was investigated. Different composite laminates were studied in order to determine the stacking sequence effects on the impact behavior of these composites. Four stacking sequences were manufactured: unidirectional [0°]8, cross-ply [0°/90°]2s, sandwich-like [02°/902°]s and quasi-isotropic [45°/0/−45°/90°]s. A low impact energy of 3.6 J was applied on these laminates by means of a drop weight impact tower. The impact properties of these lay-ups were ascertained by analysing the impact load history, the maximal displacement of the impactor and the absorbed energy. Damage after impact was further assessed by visual inspections, topographic measurements, C-scan and X-ray micro-tomography observations. The results show that impact damage of composite plates is highly influenced by fiber orientation. The impact test data are in good agreement with damage analysis after impact and indicate that stacking plies in the same orientation lead to a larger induced damage, which is responsible for energy dissipation. The quasi-isotropic composite has the smallest induced damage and the highest peak load. Otherwise, the sandwich-like sequence shows the lowest peak load, the highest energy absorption and significant induced damage. Therefore, it is necessary to choose the most suitable lay-up, in terms of impact behavior, for each considered industrial application.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.