One of the ultimate tasks for stencil lithography is the ability to fabricate arrays of structures with controlled dimensions on the nanometer scale precisely positioned on a suitable surface. The race to shrink feature sizes requires the limits of conventional lithography to be extended to high-throughput, low cost, reliable and well-controlled processes of which stencilling is a promising candidate for nanoscale applications. Identifying, predicting and overcoming issues accompanying nanostencil lithography is critical to the successful and timely development of this technique for a wide range of potential applications. This paper addresses phenomena associated with stencil nanopatterning and presents the results of modelling and simulation studies for predicting the deleterious effects of mask distortion and clogging during pattern transfer. It is shown that degrading effects of stress-induced deformation of stencils can be dealt with via optimal design of corrugation structures which in turn reduce stencil deformation and significantly improves pattern definition. Modelling results are validated by comparison to experiment. The corrugation structures can be used to define practical design rules for fabrication of stable large area (''full scale'') purpose-designed stencil membranes. The accurate modelling of the clogging phenomenon combined with gradually evolving stencil deformation, also presented in the paper, can be used for prediction of pattern distortion, to calculate maximum thickness of a deposited layer and/or for prediction of the stencil lifetime.
We present a MEMS process for the fabrication of arbitrary (adaptable to specific aperture geometries) stabilization of silicon nitride membranes to be used as miniature shadow masks or (nano) stencils. Stabilization was realized by the fabrication of silicon nitride corrugated support structures integrated into large-area thin-film solid-state membranes. These corrugated support structures are aimed to reduce the membrane deformation due to the deposition-induced stress and thus to improve the dimensional control over the surface patterns created by stencil lithography. We have performed physical vapor deposition (PVD) of chromium on unstabilized (standard) stencil membranes and on stabilized (corrugated) stencil membranes to test the proposed stabilization geometry. Both the membrane deformation and the surface structures were analyzed, showing reduced deformation and improved pattern definition for the stabilized stencil membranes. The structures have been modeled using a commercial finite element method (FEM) software tool. The simulation and experimental results confirm that introducing stabilization structures in the membrane can significantly (up to 94%) reduce out-of-plane deformations of the membrane. The results of this study can be applied as a guideline for the design and fabrication of mechanically stable, complex stencil membranes for direct deposition.
The electrostatic behaviour of micromachined cantilevers incorporating residual stress gradient and non-ideal anchors is studied in this work. Using finite-element simulation data, behavioural models that predict the electrostatic deflection and pull-in voltage of such structures have been established. The models account for the effects of residual stress gradient and real supports on the mechanical behaviour of the microcantilevers, and have been validated via comparison with experimental data. For the deflection models, the level of correlation achieved was within 7%, and in the case of pull-in voltage analysis, the calculated and measured values agree to within 4%. The completed models offer an efficient means of design, analysis and optimization of cantilever-based electrostatically actuated MEMS devices. They can also be utilized for material property measurement and analysis.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.