Magnesium fluoride is an ultraviolet (UV) transparent material which is widely used in optical applications over a wide wavelength range. We have developed a novel atomic layer deposition (ALD) process for depositing magnesium fluoride thin films for the first time. MgF2 films were grown at 250-400 degrees C using Mg( thd)(2) and TiF4 as precursors. The crystallinity, morphology, composition, thicknesses and refractive indices of the films were analyzed by X-ray diffraction/ reflection ( XRD/XRR), transmission electron microscopy ( TEM), atomic force microscopy ( AFM), field emission scanning electron microscopy ( FESEM), time-of-flight elastic recoil detection analysis ( TOF-ERDA), and UV-vis spectrophotometry. Electrical properties were also measured. The growth rate was temperature dependent decreasing from 1.6 A cycle 21 at 250 degrees C to 0.7 angstrom cycle(-1) at 400 degrees C. The films were polycrystalline at 250 - 400 degrees C. The refractive indices were between 1.34 - 1.42 and the permittivity 4.9. The impurity levels were below 0.6 at.% in the films deposited at 350 - 400 degrees C
Material mixtures offer new possibilities for synthesizing coating materials with tailored optical and mechanical properties. We present experimental results on mixtures of HfO2, ZrO2, and Al2O3, pursuing applications in UV coating technology, while the mixtures are prepared by magnetron sputtering, ion beam sputtering, plasma ion-assisted deposition (PIAD), and electron beam evaporation without assistance. The properties investigated include the refractive index, optical gap, thermal shift, and mechanical stress. The first high reflectors for UV applications have been deposited by PIAD.
A novel atomic layer deposition process for the preparation of fluoride thin films in a temperature range of 225 degrees C-400 degrees C is introduced. The crystallinity, morphology, composition, thicknesses, refractive indices, and transmittance of the films are analyzed. Low impurity levels are obtained at 350 degrees C-400 degrees C with good stoichiometry. Refractive indices of 1.34-1.42 for MgF(2), 1.43 for CaF(2), and 1.57-1.61 for LaF(3) films are obtained.
Ion-beam-sputtering (IBS) single-layer and multilayer coating designs for UV applications were examined after the deposition process as well as after a defined postdeposition treatment. High internal compressive film stress as well as moderate absorption losses in the UV spectral range were measured at the as-deposited thin films. Due to a controlled postdeposition treatment process, the absorption losses and the high compressive stress can be reduced significantly. We show that the remaining thin-film stress of SiO2 and HfO2 multilayer designs can be specifically manipulated by the parameters of the postdeposition treatment. Even zero and tensile stress can be achieved for complex multilayer coatings.
LaF(3) thin films of different thicknesses were deposited on CaF(2) (111) and silicon substrates at a relatively low substrate temperature of 150 degrees C. Optical (transmittance, reflectance, refractive index, and extinction coefficient) and mechanical (morphology and crystalline structure) properties have been investigated and are discussed. It is shown that LaF(3) thin films deposited on CaF(2) (111) substrates are monocrystalline and have a bulklike dense structure. Furthermore, it is presented that low-loss LaF(3) thin films can be deposited not only by boat evaporation but also by electron beam evaporation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.