As part of ongoing studies in polyurethane biostability and biodegradation, we have investigated an in vitro system to test strained poly(etherurethane urea) (PEUU). Recently, we utilized this system to reproduce in vivo stress cracking in strained Pellethane. In this study, strained PEUU was tested to determine whether it degrades through a common mechanism with Pellethane and to further examine the steps involved in this degradation. Biaxially strained PEUU elastomers were treated with an alpha 2-macroglobulin (alpha 2-Mac) protein solution followed by an oxidative H2O2/CoCl2 treatment. Characterization of the strained PEUU specimens was performed with attenuated total reflectance-Fourier transform infrared spectroscopy, scanning electron microscopy (SEM), electron spectroscopy for chemical analysis, and contact angle analysis. The results from these characterization techniques provide conclusive evidence that biodegradation of PEUU and Pellethane occurs through a common mechanism. Chemical changes to the PEUU include cleavage of the polyether soft segments and urethane linkages, leaving the hard segment domains unaffected. SEM analysis shows that this chain cleavage leads to the development of severe pitting and cracking of the PEUU surface. In addition, the in vitro degradation accurately reproduces the in vivo degradation chemically and physically. This result verifies that the primary species responsible for biodegradation of PEUUs, in vivo, are hydroxyl and/or hydroperoxide radicals. alpha 2-Mac pretreatment increases the rate of degradation compared to direct treatment in H2O2/CoCl2. As the PEUU soft segment chains are cleaved, the degradation products are extracted into the treatment solution or environment. Finally, a new biodegradation mechanism of PEUUs is presented that involves crosslinking of the polyether soft segments.

It is generally accepted that biodegradation of poly(etheruethane urea) (PEUU) involves oxidation of the polyether segments on the surface where leukocytes are adhered. The influence of dissolved oxygen, which is known to control oxidation of polymers in more traditional environments, was explored in this study. Specimens treated in vitro with hydrogen peroxide-cobalt chloride for 12 days exhibited a brittle, degraded surface layer about 10 microm thick. Attenuated total reflectance-Fourier transform infrared spectroscopy of the surface revealed that the ether absorbance at 1110 cm(-1) gradually decreased with in vitro treatment time to 30% of its initial value after 12 days. In contrast, 6 days in vitro followed by 6 days in air produced a decrease to 12% of the initial volume. Therefore, removing a specimen from the in vitro solution after 6 days and exposing it to air for the remainder of the 12 days actually resulted in more oxidation than leaving it in the in vitro solution for the entire 12 days. These results suggest that PEUU degrades by an autooxidation mechanism sustained by oxygen. By successfully modeling the depth of the surface degraded layer with a diffusion-reaction model, it was demonstrated that PEUU biodegradation is controlled by diffusion of oxygen into the polymer.

No abstract

Modified segmented polyurethanes were examined for biostability and biocompatibility using an in vivo cage implant system for time intervals of 1, 2, 3, 5, and 10 weeks. Two types of materials were used: polyether polyurethanes and polycarbonate polyurethanes. Two unmodified polyether polyurethanes (PEUU A' and SPU-PRM), one PDMS endcapped polyether polyurethane (SPU-S), and two polycarbonate polyurethanes (SPU-PCU and SPU-C) were investigated in this study. Techniques used to characterize untreated materials were dynamic water contact angle, stress-strain analysis, and gel permeation chromatography. Cellular response was measured by exudate analysis and by macrophage and foreign body giant cell (FBGC) densities. Material characterization, postimplantation, was done by attenuated total reflectance-Fourier transform infrared spectroscopy (ATR-FTIR) in order to quantify biodegradation and scanning electron microscopy (SEM) to qualitatively describe the cellular response and biodegradation. The exudate analysis showed that the acute and chronic inflammatory responses for all materials were similar. Lower FBGC densities and cell coverage on SPU-S were attributed to the hydrophobic surface provided by the PDMS endgroups. The polycarbonate polyurethanes did not show any significant differences in cell coverage or FBGC densities even though the macrophage densities were slightly lower compared to polyether polyurethanes. By 10 weeks, biodegradation in the case of PEUU A' and SPU-PRM was extensive as compared to SPU-S because the PDMS endcaps of SPU-S provided a shield against the oxygen radicals secreted by macrophages and FBGCs and lowered the rate of biodegradation. In the case of polycarbonate polyurethanes, the oxidative stability of the carbonate linkage lowered the rate of biodegradation tremendously as compared to the polyether polyurethanes (including SPU-S). The minor amount of biodegradation seen in polycarbonate polyurethanes at 10 weeks was attributed to hydrolysis of the carbonate linkage.

Controlled and efficient immobilization of specific biomolecules is a key technology to introduce new, favorable functions to materials suitable for biomedical applications. Here, we describe an innovative and efficient, two-step methodology for the stable immobilization of various biomolecules, including small peptides and enzymes onto TEMPO oxidized nanofibrillated cellulose (TO-NFC). The introduction of carboxylate groups to NFC by TEMPO oxidation provided a high surface density of negative charges able to drive the adsorption of biomolecules and take part in covalent cross-linking reactions with 1-ethyl-3-[3-(dimethylamino)propyl]carbodiimide (EDAC) and glutaraldehyde (Ga) chemistry. Up to 0.27 μmol of different biomolecules per mg of TO-NFC could be reversibly immobilized by electrostatic interaction. An additional chemical cross-linking step prevented desorption of more than 80% of these molecules. Using the cysteine-protease papain as model, a highly active papain-TO-NFC conjugate was achieved. Once papain was immobilized, 40% of the initial enzymatic activity was retained, with an increase in kcat from 213 to >700 s(-1) for the covalently immobilized enzymes. The methodology presented in this work expands the range of application for TO-NFC in the biomedical field by enabling well-defined hybrid biomaterials with a high density of functionalization.