The aetiological agent of amphibian chytridiomycosis Batrachochytrium dendrobatidis is a primary cause of amphibian population declines. Current surveillance is based on the detection of B. dendrobatidis in its host but in vitro work suggests infective stages may survive in the abiotic environment for at least 3 mo. We describe here a surveillance system using filtration and quantitative PCR that can detect B. dendrobatidis in small (<1 l) volumes of water. After assessing the analytical sensitivity of the protocol for both water and sediment samples in the laboratory, we analyzed environmental samples from the Sierra de Guadarrama mountain range in Spain at locations associated with chytrid-related die-offs and at other sites across Spain. B. dendrobatidis was detected in samples from 64% of the ponds in the Sierra de Guadarrama and at 2 sites outside this region, showing that levels of amphibian exposure to B. dendrobatidis are spatially heterogeneous. In experimental microcosms, we detected B. dendrobatidis for up to 12 wk, though we found no evidence for an overall increase in biomass. Our results emphasise the need to further investigate the life cycle of B. dendrobatidis to more completely understand the epidemiology of this emerging pathogen.
KEY WORDS: Chytridiomycosis · Batrachochytrium dendrobatidis · Environmental surveillance · Filtration
Resale or republication not permitted without written consent of the publisherDis Aquat Org 77: [105][106][107][108][109][110][111][112] 2007 solid culture media (Longcore et al. 1999). Thus, zoospores may persist in the environment for long periods of time and there may be hitherto undetected saprophytic stages with the ability to multiply. To better understand the biology and to analyze the epidemiology of B. dendrobatidis, a technique that can detect the pathogen in the environment and outside the host is urgently required.Traditionally, zoosporic fungi are isolated with baiting methods using the bait a substrate for the fungus (Fuller 1987). This technique works well if the objective is to characterize an unknown fungal community, but is less effective if the objective is to isolate a particular species, especially if the target species is found at low densities or is poorly competitive. Previous attempts to obtain environmental samples of Batrachochytrium dendrobatidis by using traditional baiting techniques were not successful (Longcore et al. 1999, Livo, 2004.The screening of DNA samples with environmental quantitative PCR provides a powerful tool to quantitatively detect water-and soil-borne pathogens, and its applications have been demonstrated for pathogenic Candida cells (Brinkman et al. 2003) and for Perkinsus marinus, a serious pathogen of the oyster Crassostrea virginica (Audemard et al. 2004). Here, we describe the development of a method that combines a simple, hand-held filtration system, a commercially available DNA extraction kit and a highly sensitive quantitative real-time PCR assay to detect B. dendrobatidis in small volumes (<1 l)...
The aim of this study was to assess the flexural strengths of three resin composites prepared at room temperature or cured after 20 or 40 cycles of preheating to a temperature of 45°C. Three resin composites were evaluated: Enamel Plus HFO (Micerium) (HFO), Enamel Plus HRi (Micerium) (HRi), Opallis + (FGM) (OPA). One group of specimens for each composite was fabricated under ambient laboratory conditions, whereas in the other groups, the composites were cured after 20 or 40 preheating cycles to a temperature of 45°C in a preheating device. Ten specimens were prepared for each group. A three-point bending test was performed using a universal testing machine at a crosshead speed of 0.5 mm/min. Data were analyzed with a two-way analysis of variance (ANOVA) test and a Games-Howell test (α = 0.05). The two-way ANOVA showed that both the material and the number of heating cycles were significant factors, able to influence the flexural strength values (p<0.05). However, there was not a statistically significant interaction (p>0.05). For all three composites flexural strengths were not affected after 20 preheating cycles in comparison with the control groups (0 preheating cycles) but were, however, significantly decreased when 40 prewarming cycles were conducted. The HRi and OPA groups had the highest flexural strengths, with no statistically significant differences among them. HFO presented significantly lower flexural strengths in comparison with HRi.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.