Water shortage is a major worldwide issue. Filtration using genuine polymeric membranes demonstrates excellent pollutant separation capabilities; however, polymeric membranes have restricted uses. Nanocomposite membranes, which are produced by integrating nanofillers into polymeric membrane matrices, may increase filtration. Carbon-based nanoparticles and metal/metal oxide nanoparticles have received the greatest attention. We evaluate the antifouling and permeability performance of nanocomposite membranes and their physical and chemical characteristics and compare nanocomposite membranes to bare membranes. Because of the antibacterial characteristics of nanoparticles and the decreased roughness of the membrane, nanocomposite membranes often have greater antifouling properties. They also have better permeability because of the increased porosity and narrower pore size distribution caused by nanofillers. The concentration of nanofillers affects membrane performance, and the appropriate concentration is determined by both the nanoparticles’ characteristics and the membrane’s composition. Higher nanofiller concentrations than the recommended value result in deficient performance owing to nanoparticle aggregation. Despite substantial studies into nanocomposite membrane manufacturing, most past efforts have been restricted to the laboratory scale, and the long-term membrane durability after nanofiller leakage has not been thoroughly examined.
A novel, cheap, less toxic, and easier-prepared gelatin surfactant is successfully used as corrosion inhibitor for the corrosion of copper in 0.1 M H 2 SO 4 at the temperature range: 25-55 C. The critical micelle concentration of the surfactant was determined from surface tension measurements. The inhibition efficiency was determined from potentiodynamic polarization and electrochemical impedance spectroscopy techniques. For surfactant acted by adsorption at copper/solution interface, an inhibition efficiency up to 68 was obtained at critical micelle concentration (70 ppm) of surfactant at 35 C. The free energy of adsorption was calculated and discussed. The surface parameters of gelatin surfactant were calculated and correlated to the inhibition efficiency. They were also calculated from its surface tension profile including: critical micelle concentration), maximum surface excess (C max ), and minimum surface area (A min ). The thermodynamic of micellization, free energies of micellization (DG mic ) and entropy of micellization, was calculated and discussed. The formation of compact and adherent monomolecular adsorbed film on copper substrate was confirmed.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.