With the objective of developing a recombinant oxygen carrier suitable for therapeutic applications, we have employed an Escherichia coli expression system to synthesize in high-yield hemoglobin (Hb) Minotaur, containing alpha-human and beta-bovine chains. Polymerization of Hb Minotaur through S-S intermolecular cross-linking was obtained by introducing a Cys at position beta9 and substituting the naturally occurring Cys. This homogeneous polymer, Hb Polytaur, has a molecular mass of approximately 500 kDa and was resistant toward reducing agents present in blood. In mice, the circulating half-time (3 h) was fivefold greater than adult human Hb (HbA). The half-time of autooxidation measured in blood (46 h) exceeded the circulating retention time. Hypervolemic exchange transfusion resulted in increased arterial blood pressure similar to that with albumin. The increase in pressure was less than that obtained by transfusion of cross-linked tetrameric Hb known to undergo renovascular extravasation. The nitric oxide reactivity of Hb Polytaur was similar to HbA, suggesting that the diminished pressor response to Hb Polytaur was probably related to diminished extravasation. Transfusion of 3% Hb Polytaur during focal cerebral ischemia reduced infarct volume by 22%. Therefore, site-specific Cys insertion on the Hb surface results in uniform size polymers that do not produce the large pressor response seen with tetrameric Hb. Polymerization maintains physiologically relevant oxygen and heme affinity, stability toward denaturation and oxidation, and effective oxygen delivery as indicated by reduced cerebral ischemic damage.

Previous studies have suggested that thrombin interacts with integrins in endothelial cells through its RGD (Arg-187, Gly-188, Asp-189) sequence. All existing crystal structures of thrombin show that most of this sequence is buried under the 220-loop and therefore interaction via RGD implies either partial unfolding of the enzyme or its proteolytic digestion. Here, we demonstrate that surface-absorbed thrombin promotes attachment and migration of endothelial cells through interaction with ␣ v ␤ 3 and ␣ 5 ␤ 1 integrins. Using site-directed mutants of thrombin we prove that this effect is mediated by the RGD sequence and does not require catalytic activity. The effect is abrogated when residues of the RGD sequence are mutated to Ala and is not observed with proteases like trypsin and tissue-type plasminogen activator, unless the RGD sequence is introduced at position 187-189. The potent inhibitor hirudin does not abrogate the effect, suggesting that thrombin functions through its RGD sequence in a non-canonical conformation. A 1.9-Å resolution crystal structure of free thrombin grown in the presence of high salt (400 mM KCl) shows two molecules in the asymmetric unit, one of which assumes an unprecedented conformation with the autolysis loop shifted 20 Å away from its canonical position, the 220-loop entirely disordered, and the RGD sequence exposed to the solvent.

The oxyanion hole of serine proteases is formed by the backbone N atoms of the catalytic Ser-195 and Gly-193 and engages the backbone O atom of the P1 residue of substrate in an important H-bonding interaction. The energetic contribution of this interaction in the ground and transition states is presently unknown. Measurements of the individual rate constants defining the catalytic mechanism of substrate hydrolysis for wild-type thrombin and trypsin and their G193A and G193P mutants reveal that Gly-193 is required for optimal substrate binding and acylation. Crystal structures of the G193A and G193P mutants of thrombin bound to the active site inhibitor H-D-Phe-Pro-Arg-CH 2 Cl document the extent of perturbation induced by the replacement of Gly-193. The Ala mutant weakens the H-bonding interaction of the N atom of residue 193, whereas the Pro substitution abrogates it altogether with additional small shifts of the protein backbone. From the kinetic and structural data, we estimate that the H-bonding interaction in the oxyanion hole contributes a stabilization of the ground and transition states of >1.5 kcal/mol but <3.0 kcal/mol. These results shed light on a basic aspect of the enzyme-substrate interaction in the entire family of trypsin-like serine proteases.Serine proteases catalyze the hydrolysis of peptide bonds using the triad His-57/Asp-102/Ser-195 (chymotrypsinogen numbering) (1, 2). Binding of substrate to the active site is stabilized by a network of H-bonds, five of which are highly conserved and ensure the efficient hydrolysis of amide bonds. Of these H-bonds, two stabilize an anti-parallel ␤-sheet between Gly-216 and the P3 residue of substrate, whereas the other three involve the backbone N and O atoms of the P1 residue of substrate. The N atom engages the backbone O atom of Ser-214, often referred to as the "fourth" member of the catalytic machinery (3). The O atom of the P1 residue, on the other hand, makes two H-bonding interactions with the backbone N atoms of the catalytic in the so-called "oxyanion hole." The role of this region of the enzyme is to stabilize the developing negative charge on the O atom of substrate during formation of the tetrahedral intermediate (4). The lack of a side chain at position 193 allows correct positioning of the amido hydrogen to form the requisite H-bond with the oxyanion substrate. Indeed, Gly is highly conserved at position 193 in serine proteases, but few exceptions do exist and are associated with perturbed substrate hydrolysis and resistance to inhibition (5-8).Previous studies have addressed the important question of the energetic involvement of the oxyanion hole in substrate recognition. In subtlisin, one of the H-bonding group in the oxyanion hole is provided by the side chain of Asn-155 (9). Mutation of Asn-155 to the isosteric Leu, devoid of H-bonding capabilities, produces a derivative with reduced k cat /K m due to a significant (200-fold) decrease of k cat (9, 10). The absence of effect on K m has been interpreted as supporting the role of the H-b...

We have engineered a recombinant mutant human hemoglobin, Hb Prisca beta(S9C+C93A+C112G), which assembles in a polymeric form. The polymerization is obtained through the formation of intermolecular S-S bonds between cysteine residues introduced at position beta9, on the model of Hb Porto Alegre (beta9Ser --> Cys) (Bonaventura and Riggs, Science 1967;155:800-802). Cbeta93 and Cbeta112 were replaced in order to prevent formation of spurious S&bond;S bonds during the expression, assembly, and polymerization events. Dynamic light scattering measurements indicate that the final polymerization product is mainly formed by 6 to 8 tetrameric hemoglobin molecules. The sample polydispersity Q = 0.07 +/- 0.02, is similar to that of purified human hemoglobin (Q = 0.02 +/- 0.02), consistent with a good degree of homogeneity. In the presence of strong reducing agents, the polymer reverts to its tetrameric form. During the depolymerization process, a direct correlation is observed between the hydrodynamic radius and the light scattering of the system, which, in turn, is proportional to the mass of the protein. We interpret this to indicate that the hemoglobin molecules are tightly packed in the polymer with no empty spaces. The tight packing of the hemoglobin molecules suggests that the polymer has a globular shape and, thus, allows estimation of its radius. An illustration of an arrangement of a finite number of tetrameric hemoglobin molecules is presented. The conformational and functional characteristics of this polymer, such as heme pocket conformation, stability to denaturation, autoxidation rate, oxygen affinity, and cooperativity, remain similar to those of tetrameric human hemoglobin.