3 0

Increased generation of methane (CH4) from municipal solid wastes (MSW) alarms the world to take proper initiative for the sustainable management of MSW, because it is 34 times stronger than carbon dioxide (CO2). Mounting land scarcity issue around the world brands the waste to energy (WtE) strategy for MSW management in urban areas as a promising option, because WtE not only reduces the land pressure problem, but also generates electricity, heat, and green jobs. The goal of this study is to evaluate the renewable electricity generation potential and associated carbon reduction of MSW management in Bangladesh using WtE strategies. The study is conducted in two major cities of Bangladesh: Dhaka and Chittagong. Six different WtE scenarios are evaluated consisting of mixed MSW incineration and landfill gas (LFG) recovery system. Energy potential of different WtE strategy is assessed using standard energy conversion model and subsequent GHGs emissions models. Scenario A1results in highest economic and energy potential and net negative GHGs emission. Sensitivity analysis by varying MSW moisture content reveals higher energy potential and less GHGs emissions from MSW possessing low moisture content. The study proposes mixed MSW incineration that could be a potential WtE strategy for renewable electricity generation in Bangladesh.

Improving human health is a long-lasting endeavour of mankind. In the field of social life cycle assessment (SLCA), the importance of human health is often highlighted, and further development of impact assessment methods has been recommended. The purpose of this article is to present a method for assessing human health impacts within SLCA. Methods By using a systematic combining approach, knowledge and experience about assessing human health impacts were obtained from three previously conducted case studies. The first case study was about an airbag system, the second about a catalytic converter and the third about gold jewellery. The disability-adjusted life years (DALY) indicator was used for impact assessment in all three case studies. Results and discussion Both positive and negative human health impacts associated with the products were identified and assessed in the three case studies. For the airbag system, avoided health impacts in the use phase outweighed health impacts during production. For the catalytic converter, whether health impacts avoided exceeded health impacts caused or not depended on which time perspective regarding impacts was employed. Gold jewellery does not help avoiding any health impacts but caused considerable health impacts when produced at a certain location. Based on experience from these case studies, a generic human health impact assessment method was developed, and a life cycle human health typology for products was developed based on the method. The method provides a basis for analysis and interpretation of health impacts along product life cycles, and it is therefore important to report both positive and negative health impacts separately for different actors. Conclusions The developed human health impact assessment method involves the assessment and comparison of both positive and negative human health impacts along product life cycles. In addition to the products assessed in the three case studies, we suggest additional products that could be particularly interesting to assess with the developed method, including medicines, seat belts, other conflict minerals, alcoholic beverages and products with a high chemical impact.

No abstract

No abstract