The article presents the course and results of the procedure for verifying the stability of the cylindrical shell of an oil tank with a floating roof, under wind load. Two dimensioning methods recommended by standard PN-EN 1993-1-6 were used, i.e. dimensioning based on the stress state and the MNA-LBA procedure. The method of determining the critical buckling resistance ratio from the linear bifurcation analysis (LBA) and the plastic reference resistance ratio from the physically nonlinear analysis (MNA) has been presented. Comparison of the results obtained with the use of the indicated design methods revealed significant discrepancies in the stress intensity levels of the analysed shell. When using the stress-based dimensioning method, it was shown that the buckling strength was exceeded by 33%, while the results of the MNA-LBA procedure indicated a 33% reserve of the capacity of the analysed system.
In this paper a new approach to the consistent identification of the deformation pattern vital for the precise determination of the plastic limit load of a cylindrical shell from MNA when using modified Southwell (MS) and Tangent Stiffness (TS) plots is presented. It is proposed that the formalised assessment of the plastic collapse load can be done by the application of the relation between the load factor increment Δr R and the arc length s -for an identification of achievement of the complete plastic collapse mechanism from MNA, and then the MS or TS plot for the displacement pattern that corresponds to the identified plastic mechanism.Streszczenie W artykule przedstawiono metodę pozwalającą na jednoznaczną identyfikację postaci deformacji kluczowej w procesie wyznaczania nośności plastycznej powłoki cylindrycznej z analizy MNA, przy zastosowaniu zmodyfikowanej zależności Southwella (MS) oraz metody sztywności stycznej (TS). Proponuje się, żeby formalna ocena plastycznego obciążenia niszczącego oparta była na wykorzystaniu zależności między przyrostem mnożnika obciążenia Δr R i długością łuku s -w celu identyfikacji momentu osiągnięcia w analizie kompletnego mechanizmu zniszczenia, a następnie zastosowaniu wykresów zależności MS i TS dla postaci deformacji stowarzyszonej z wskazanym wcześniej mechanizmem.Słowa kluczowe: powłoka cylindryczna, zniszczenie plastyczne, analiza nieliniowa
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.