Activated carbon (AC) air cathodes were constructed using variable amounts of carbon (43-171 mg cm 22 ) and an inexpensive binder (10 wt% polytetrafluoroethylene, PTFE), and with or without a porous cloth wipe-based diffusion layer (DL) that was sealed with PDMS. The cathodes with the highest AC loading of 171 mg cm 22 , and no diffusion layer, produced 1255 ¡ 75 mW m 22 and did not appreciably vary in performance after 1.5 months of operation. Slightly higher power densities were initially obtained using 100 mg cm 22 of AC (1310 ¡ 70 mW m 22 ) and a PDMS/wipe diffusion layer, although the performance of this cathode decreased to 1050 ¡ 70 mW m 22 after 1.5 months, and 1010 ¡ 190 mW m 22 after 5 months. AC loadings of 43 mg cm 22 and 100 mg cm 22 did not appreciably affect performance (with diffusion layers). MFCs with the Pt catalyst and Nafion binder initially produced 1295 ¡ 13 mW m 22 , but the performance decreased to 930 ¡ 50 mW m 22 after 1.5 months, and then to 890 ¡ 20 mW m 22 after 5 months. Cathode performance was optimized for all cathodes by using the least amount of PTFE binder (10%, in tests using up to 40%). These results provide a method to construct cathodes for MFCs that use only inexpensive AC and a PTFE, while producing power densities similar to those of Pt/C cathodes. The methods used here to make these cathodes will enable further tests on carbon materials in order to optimize and extend the lifetime of AC cathodes in MFCs.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.