J-R. (2019). 81 supra-THz beams generated by a Fourier grating and a quantum cascade laser. Optics Express, 27(23), 34193-34204. https://doi.Abstract: Large heterodyne receiver arrays (~100 pixel) allow astronomical instrumentations to map more area within limited space mission lifetime. One challenge is to generate multiple local oscillator (LO) beams. Here, we succeeded in generating 81 beams at 3.86 THz by combining a reflective, metallic Fourier grating with an unidirectional antenna coupled 3rdorder distributed feedback (DFB) quantum cascade laser (QCL). We have measured the diffracted 81 beams by scanning a single pyroelectric detector at a plane, which is in the far field for the diffraction beams. The measured output beam pattern agrees well with a simulated result from COMSOL Multiphysics, with respect to the angular distribution and power distribution among the 81 beams. We also derived the diffraction efficiency to be 94 ± 3%, which is very close to what was simulated for a manufactured Fourier grating (97%). For an array of equal superconducting hot electron bolometer mixers, 64 out of 81 beams can pump the HEB mixers with similar power, resulting in receiver sensitivities within 10%. Such a combination of a Fourier grating and a QCL can create an LO with 100 beams or more, enabling a new generation of large heterodyne arrays for astronomical instrumentation.

We present a terahertz spatial filter consisting of two back-to-back (B2B) mounted elliptical silicon lenses and an opening aperture defined on a thin gold layer between the lenses. The beam filtering efficiency of the B2B lens system is investigated by simulation and experiment. Using a unidirectional antenna coupled 3rd-order distributed feedback (DFB) quantum cascade laser (QCL) at 3.86 THz as the source, the B2B lens system shows 72% transmissivity experimentally with a fundamental Gaussian mode as the input, in reasonably good agreement with the simulated value of 80%. With a proper aperture size, the B2B lens system is capable of filtering the non-Gaussian beam from the QCL to a nearly fundamental Gaussian beam, where Gaussicity increases from 74% to 99%, and achieves a transmissivity larger than 30%. Thus, this approach is proven to be an effective beam shaping technique for QCLs, making them to be suitable local oscillators in the terahertz range with a Gaussian beam. Besides, the B2B lens system is applicable to a wide frequency range if the wavelength dependent part is properly scaled.

Heterodyne receivers combining a NbN HEB mixer with a local oscillator (LO) are the work horse for high resolution ( ≥10 6 ) spectroscopic observations at supra-terahertz frequencies. We report an MgB2 HEB mixer working at 5.3 THz with 20 K operation temperature based on a previously published paper [Y. Gan et al, Appl. Phys. Lett., 119, 202601 (2021)]. The HEB consists of a 7 nm thick MgB2 submicron-bridge contacted with a spiral antenna. It has a Tc of 38.4 K. By using hot/cold blackbody loads and a Mylar beam splitter all in vacuum, and applying a 5.25 THz FIR gas laser as the LO, we measured a minimal DSB receiver noise temperature of 3960 K. The latter gives a DSB mixer noise temperature of 1470 K. This sensitivity is 28 times better than a room temperature Schottky mixer at 4.7 THz, but about 2.5 times less sensitive than an NbN HEB mixer. The latter must be operated around 4 K. The IF noise bandwidth is about 10 GHz, which is 2.5-3 times larger than an NbN HEB. With further optimization, such MgB2 HEBs are expected to reach a better sensitivity. That the low noise, wide IF bandwidth MgB2 HEB mixers can be operated in a compact, low dissipation 20 K Stirling cooler can significantly reduce the cost and complexity of heterodyne instruments and therefore facilitate new space missions.

No abstract