The features of ion and electron fishbone instabilities have been investigated during neutral beam injection (NBI) and electron cyclotron resonance heating (ECRH) on HL-2A. Some new phenomena, such as frequency jumps and V-font-style sweeping, have been presented in the paper. Three kinds of i-fishbones, including hybrid sawtoothfishbone (sawbone), run-on fishbone and classical fishbone, have been identified during NBI. During high power (P ECRH > 0.7 MW) ECRH, the experimental results indicate that the e-fishbone frequencies are higher than those during low power ECRH, and are provided with up-and down-chirping behaviours, and sometimes also with V-font-style sweeping. The periodic mode frequency jumps have also been detected by a soft x-ray array. It is possible to correlate these phenomena with the redistribution of energetic electrons.

Density profiles in pedestal region (H-mode) are measured in HL-2A and the characteristics of the density pedestal are described. Cold particle deposition by Supersonic Molecular Beam Injection (SMBI) within the pedestal is verified. ELM mitigation by SMBI into the H-mode pedestal is demonstrated and the relevant physics is elucidated. The sensitivity of the effect to SMBI pressure and duration are studied. Following SMBI, the ELM frequency increases and ELM amplitude decreases for a finite duration period. Increases in ELM frequency of SMBI ELM f / 0 ELM f 2-3.5 are achieved. This experiment argues that the ELM mitigation results from an increase in Page 2 higher frequency fluctuations and transport events in the pedestal, which are caused by SMBI. These inhibit the occurrence of large transport events which span the entire pedestal width. The observed change in the density pedestal profiles and edge particle flux spectrum with and without SMBI supports this interpretation. An analysis of the experiment and a model shows that ELMs can be mitigated by SMBI with shallow particle penetration into the pedestal.

Strong m = 1 MHD activities are observed in the HL-1M tokamak during off-axis electron cyclotron resonance heating (ECRH) when the cyclotron resonance location is placed just outside the q = 1 surface at the high-magnetic-field side of the magnetic surface. Addition of lower-hybrid waves to ECRH significantly enhances the MHD excitation, but lower-hybrid waves alone cannot excite or sustain the mode. This result is a clear demonstration of the suprathermal trapped electron effect on the instability because of the absence of energetic ions in the plasma.

Typical ELMy H-mode discharges have been achieved on the HL-2A tokamak with combined auxiliary heating of NBI and ECRH. The minimum power required is about 1.1 MW at a density of 1.6 × 10 19 m −3 and increases with a decrease in density, almost independent of the launching order of the ECRH and NBI heating. The energy loss by each edge localized mode (ELM) burst is estimated to be lower than 3% of the total stored energy. At a frequency of typically 400 Hz, the energy confinement time is only marginally reduced by the ELMs. The supersonic molecular beam injection fuelling is found to be beneficial for triggering an L-H transition due to less induced recycling and higher fuelling efficiency. The dwell time of the L-H transition is 20-200 ms, and tends to decrease as the power increases. The delay time of the H-L transition is 10-30 ms for most discharges and is comparable to the energy confinement time. The ELMs with a period of 1-3 ms are sustained for more than ten times the energy confinement time with enhanced confinement factor H 89 > 1.5, which tends to decrease with the total heating power. The confinement time in the H-mode discharges increases with plasma current approximately linearly.

Ion internal transport barriers (iITBs) are first observed in neutral beam injection (NBI) heated plasmas at the HL-2A tokamak. The position of the barrier foot, in the stationary state, coincides with the q  =  1 surface within its uncertainty of measurement. iITBs can develop more easily at the beginning of NBI heating. Also, iITBs are unstable for the sawtooth plasma. Simulations reveal that the thermal diffusivity of ions (χ i) inside the barrier can be as low as the neoclassical level. It is observed that the flow shear in the stationary iITB state reaches the level required for suppressing the ion temperature gradient mode instability, which indicates the important role of flow shear in sustaining the iITB.