We evaluated the efficiency of an air purifier using the single-chamber method for the effective removal of airborne Staphylococcus epidermidis, a nosocomial infection-causing bacterium. In this experiment, the bacterial strain S. epidermidis was injected using a nebulizer into the test chamber, which was similar to a consumer living space (60 m 3 ). The microbial sampling was conducted via the air sampler method, and the reduction in S. epidermidis growth was monitored by performing three consecutive tests. Initially, a blank test was conducted to determine the natural decay rate and calibrate the experimental setup. After injecting the bacterial strain from 1240 to 11180 CFU per unit volume (m 3 ), the natural decay rate showed a maximum deviation of 3.1% with a sampling error of 1.1% p at a confidence level of 95%. In addition, the particle size distribution in the test chamber was found to range from 0.3 to 5.0 μm, and a subsequent decrease in large-sized particles was observed with the operation of the air purifier, which is the size similar to that of suspended airborne bacteria. This can be used to assess the performance of the air purifier by calibrating the natural reduction value to the reduced operation value. Thus, the single-chamber technique is a promising approach for analyzing the removal efficacy of airborne bacteria from indoor air.

Zinc oxide nanoparticles (ZnO) have long been utilized as UV-protective sunscreen components due to their high durability and lower skin irritation while maintaining capability for blocking UV rays. However, the dispersal and transparency properties of ZnO need to be enhanced in order to improve the capacity for creating effective sunscreen through control of the physiochemical properties of ZnO. In this study, chitosan or niacinamide, which are suitable functional cosmetic compounds and effective skin lightening agents, are combined with ZnO for the development of better UV-protective products. Each biocompatible coating material is individually attached on its surface after the synthesis of ZnO. The size is 70 nm using the sol-gel method. Their morphology and chemical structure are characterized by FT-IR, XRD, SEM, TEM, TGA, and zeta potential. The results indicate that approximately 50% of chitosan and 5% niacinamide were coated on the ZnO. To confirm the capacity of each surface-coated ZnO with chitosan and niacinamide as a sunscreen, we measured their transmission, reflectance, and sun protection factor (SPF) using a UV spectrophotometer and SPF. As a result, the niacinamide-coated ZnO shows remarkably lower transmission and high reflectance against UV rays than that of bare ZnO and chitosan-coated ZnO. Furthermore, niacinamide-coated ZnO exhibits great lightening effects. Consequently, these results demonstrate that niacinamide coating is highly effective for the production of sunscreen emulsions.