We report on the structure and evolution of a current sheet that formed in the wake of an eruptive X8.3 flare observed at the west limb of the Sun on September 10, 2017. Using observations from the EUV Imaging Spectrometer (EIS) on Hinode and the Atmospheric Imaging Assembly (AIA) on the Solar Dynamics Observatory (SDO), we find that plasma in the current sheet reaches temperatures of about 20 MK and that the range of temperatures is relatively narrow. The highest temperatures occur at the base of the current sheet, in the region near the top of the post-flare loop arcade. The broadest high temperature line profiles, in contrast, occur at the largest observed heights. Further, line broadening is strong very early in the flare and diminishes over time. The current sheet can be observed in the AIA 211 and 171 channels, which have a considerable contribution from thermal bremsstrahlung at flare temperatures. Comparisons of the emission measure in these channels with other EIS wavelengths and AIA channels dominated by Fe line emission indicate a coronal composition and suggest that the current sheet is formed by the heating of plasma already in the corona. Taken together, these observations suggest that some flare heating occurs in the current sheet while additional energy is released as newly reconnected field lines relax and become more dipolar.

We present a study of the X2-class flare which occurred on 2014 October 27 and was observed with the Interface Region Imaging Spectrograph (IRIS) and the EUV Imaging Spectrometer (EIS) on board the Hinode satellite. Thanks to the high cadence and spatial resolution of the IRIS and EIS instruments, we are able to compare simultaneous observations of the Fe XXI1354.08 Åand Fe XXIII263.77 Åhigh-temperature emission (10 MK) in the flare ribbon during the chromospheric evaporation phase. We find that IRIS observes completely blueshifted Fe XXIline profiles, up to 200 km s −1 during the rise phase of the flare, indicating that the site of the plasma upflows is resolved by IRIS. In contrast, the Fe XXIIIline is often asymmetric, which we interpret as being due to the lower spatial resolution of EIS. Temperature estimates from SDO/AIA and Hinode/XRT show that hot emission (log(T[K]) >7.2) is first concentrated at the footpoints before filling the loops. Density-sensitive lines from IRIS and EIS give estimates of electron number density of 10 12 cm −3 in the transition region lines and 10 10 cm −3 in the coronal lines during the impulsive phase. In order to compare the observational results against theoretical predictions, we have run a simulation of a flare loop undergoing heating using the HYDRAD 1D hydro code. We find that the simulated plasma parameters are close to the observed values that are obtained with IRIS, Hinode, and AIA. These results support an electron beam heating model rather than a purely thermal conduction model as the driving mechanism for this flare.