This letter presents a study of prospects of searching for excited leptons during Run II of the Fermilab Tevatron. We concentrate on single and pair production of excited electrons in the photonic decay channel in one CDF/DØ detector equivalent for 2 fb −1 . By the end of Run IIa, the limits should be easily extended beyond those set by LEP and HERA for excited leptons with mass above about 190 GeV.

No abstract

Block copolymer vesicles are powerful tools for investigating cell adhesion since they display the fluid, deformable, semipermeable membrane properties of lipid vesicles while having greater chemical and mechanical stability. The aim of the present study was to fabricate block copolymer vesicles containing hydrogel interiors in order to extend achievable vesicle properties and, thereby, their range of cell-like behaviors. Block copolymer vesicles based on poly(butadiene-b-ethylene oxide) were demonstrated to compartmentalize and retain acrylamide solutions through particle dialysis and to allow for subsequent in situ hydrogel polymerization. Small molecule leakage studies of the resulting particles indicated that the cross-link density of the hydrogel interiors had minimal impact on vesicle permeability to small molecules (<430 Da) relative to vesicle membrane properties. In contrast, particle deformation analyses indicated that initial vesicle surface approach and adhesion was dominated by its membrane properties, whereas its ultimate deformation was primarily governed by the hydrogel interior. Thus, the hydrogel-containing vesicles allowed orthogonal control of particle surface and mechanical properties. Analysis of particle behavior in terms of Gibb's free energy minimization indicated that vesicle adhesion energy, membrane tension, and internal osmotic pressure dominated particle adhesion and deformation. Combined, the present work demonstrates the potential for designing compartmentalized, hierarchical polymer-based cell mimics with broadly tunable dynamic-mechanical properties and surface properties.

Poly(dimethylsiloxane-ethylene oxide) (PDMS-PEO) and poly(butadiene-b-ethylene oxide) (PBd-PEO) are two block copolymers which separately form vesicles with disparate membrane permeabilities and fluidities. Thus, hybrid vesicles formed from both PDMS-PEO and PBd-PEO may ultimately allow for systematic, application-specific tuning of vesicle membrane fluidity and permeability. However, given the relatively low strength previously noted for comb-type PDMS-PEO vesicles, the mechanical robustness of the resulting hybrid vesicles must first be confirmed. Toward this end, we have characterized the mechanical behavior of vesicles formed from mixtures of linear PDMS-PEO and linear PBd-PEO using micropipette aspiration. Tension versus strain plots of pure PDMS12-PEO46 vesicles revealed a non-linear response in the high tension regime, in contrast to the approximately linear response of pure PBd33-PEO20 vesicles. Remarkably, the area expansion modulus, critical tension, and cohesive energy density of PDMS12-PEO46 vesicles were each significantly greater than for PBd33-PEO20 vesicles, although critical strain was not significantly different between these vesicle types. PDMS12-PEO46/PBd33-PEO20 hybrid vesicles generally displayed graded responses in between that of the pure component vesicles. Thus, the PDMS12-PEO46/PBd33-PEO20 hybrid vesicles retained or exceeded the strength and toughness characteristic of pure PBd-PEO vesicles, indicating that future assessment of the membrane permeability and fluidity of these hybrid vesicles may be warranted.