No abstract

Six-membered cyclic carbonates, namely trimethylene carbonate (TMC), 3,3-dimethoxytrimethylene carbonate (DMTMC) and 3-benzyloxytrimethylene carbonate (BTMC), undergo controlled "immortal" ring-opening polymerization (iROP) under mild conditions (bulk, 60-150 °C), by using organocatalysts, including an amine [4-N,N-dimethylaminopyridine (DMAP)], a guanidine [1,5,7-triazabicyclo-[4.4.0]dec-5-ene (TBD)], or a phosphazene [2-tert-butylimino-2-diethylamino-1,3-dimethylperhydro-1,3,2-diazaphosphorine (BEMP)], in the presence of an alcohol [benzyl alcohol (BnOH), 1,3-propanediol (PPD), glycerol (GLY)] that acts as both a co-initiator and a chain-transfer agent. Remarkably, such organocatalysts remain highly active in the iROP of technical-grade, unpurified TMC. Under optimized conditions, as much as 100,000 equivalents of TMC were fully converted by as little as 10 ppm of BEMP with the simultaneous growth of as many as 200 polymer chains, allowing the preparation of high molar mass poly(trimethylene carbonate)s (up to 45,800 g mol(-1)). These catalyst systems enable among the highest activities (TOF=55,800 h(-1)) and productivities (TON=95,000) ever reported for the ROP of TMC.

International audienceThe ring-opening polymerization (ROP) of racemic trans-cyclohexene carbonate (rac-CHC) and enantiopure trans-(R,R)-CHC is successfully carried out with various catalyst systems. Poly(cyclohexene carbonate) (PCHC) with a slight isotactic bias (Pm = ca. 60–76%) is obtained by ROP of rac-CHC catalyzed by zinc diaminophenolate, zinc β-diketiminate, yttrium bis(phenolate), or 1,5,7-triazabicyclo[4.4.0]dec-5-ene (TBD) in combination with an alcohol as a co-initiator. Purely isotactic PCHC is synthesized for the first time via ROP of enantiopure (R,R)-CHC with a zinc/benzyl alcohol catalyst system. All reactions proceed without decarboxylation, affording well-defined PCHCs with Mn,NMR up to 17 000 g mol–1 and ĐM = ca. 1.2. Purely isotactic PCHC is semicrystalline, with Tg = 130 °C, Tc = 162 °C, and Tm = 248 °C. DFT computations further highlight the significant favorable impact of the trans-cyclohexane ring-strain to enable the ROP of CHC, as opposed to meso-CHC which is unreactive

International audienceα,ω-Di(glycerol carbonate) telechelic poly(propylene glycol) (PPG), poly(ethylene glycol) (PEG), poly(ester ether) (PEE), and poly(butadiene) (PBD) have been synthesized through chemical modification of the corresponding α,ω-dihydroxy telechelic polymers (PPG-OH2, PEG-OH2, PEE-OH2 and PBD-OH2, respectively). Tosylation of the polymer diols with 4-tosylmethyl-1,3-dioxolan-2-one (GC-OTs) afforded, in high yields, the desired PPG, PEG, PEE and PBD end-capped at both termini with a five-membered ring cyclic glycerol carbonate (4-hydroxymethyl-1,3-dioxolan-2-one, GC). The GC-functionalization of the polymers at both chain-ends has been confirmed by NMR (1H, 13C, 1D and 2D) and FTIR spectroscopies. Using PPG-GC2 to demonstrate the concept, the corresponding polyhydroxyurethanes (PHUs/non-isocyanate polyurethanes (NIPUs)) have been subsequently prepared following a non-isocyanate method upon ring-opening catalyst-free polyaddition of the PPG-GC2 with JEFFAMINEs (Mn = 230-2000 g mol−1). The effect of various additives introduced during the polyaddition reaction has been studied at different temperatures. In particular, addition of LiBr (5 mol%) to the reaction medium was found to slightly promote the cyclocarbonate/amine reaction. The polymerization process was supported by FTIR and SEC analyses

ROMP/CM of COE using bis(trialkoxysilyl)alkenes CTAs and Ru catalysts affords a series of bis(trialkoxysilyl) difunctionalized polyolefins.