In 2011 we acquired an 11 × 55 km, 3-D seismic reflection volume across the Costa Rica margin, NW of the Osa Peninsula, to accurately image the subduction thrust in 3-D, to examine fault zone properties, and to infer the hydrogeology that controls fluid accumulation along the thrust. Following processing to remove water column multiples, noise, and acquisition artifacts, we constructed a 3-D seismic velocity model for Kirchhoff prestack depth migration imaging. Images of the plate boundary thrust show high-reflection amplitudes underneath the middle to lower slope that we attribute to fluid-rich, poorly drained portions of the subduction thrust. At~5 km subseafloor, beneath the upper slope, the plate interface abruptly becomes weakly reflective, which we interpret as a transition to a well-drained subduction thrust. Mineral dehydration during diagenesis may also diminish at 5 km subseafloor to reduce fluid production and contribute to the downdip change from high to low amplitude. There is also a layered fabric and systems of both thrust and normal faults within the overriding plate that form a "plumbing system." Faults commonly have fault plane reflections and are presumably fluid charged. The faults and layered fabric form three compartmentalized hydrogeologic zones: (1) a shallow NE dipping zone beneath the slope, (2) a steeply SW dipping zone beneath the shelf slope break, and (3) a NE dipping zone beneath the shelf. The more direct pathway in the middle zone drains the subduction thrust more efficiently and contributes to reduced fluid pressure, elevates effective stress, and creates greater potential for unstable coseismic slip.

Here we propose a new framework for forearc evolution that focuses on the potential feedbacks between subduction tectonics, sedimentation, and geomorphology that take place during an extreme event of subduction erosion. These feedbacks can lead to the creation of a ''depositionary forearc,'' a forearc structure that extends the traditional division of forearcs into accretionary or erosive subduction margins by demonstrating a mode of rapid basin accretion during an erosive event at a subduction margin. A depositionary mode of forearc evolution occurs when terrigenous sediments are deposited directly on the forearc while it is being removed from below by subduction erosion. In the most extreme case, an entire forearc can be removed by a single subduction erosion event followed by depositionary replacement without involving transfer of sediments from the incoming plate. We need to further recognize that subduction forearcs are often shaped by interactions between slow, long-term processes, and sudden extreme events reflecting the sudden influences of large-scale morphological variations in the incoming plate. Both types of processes contribute to the large-scale architecture of the forearc, with extreme events associated with a replacive depositionary mode that rapidly creates sections of a typical forearc margin. The persistent upward diversion of the megathrust is likely to affect its geometry, frictional nature, and hydrogeology. Therefore, the stresses along the fault and individual earthquake rupture characteristics are also expected to be more variable in these erosive systems than in systems with long-lived megathrust surfaces.

[1] We used high-resolution mapping to document 161 sites of potential fluid seepage on the shelf and slope regions where no geophysical seep indicators had been reported. Identified potential seabed seepage sites show both high-backscatter anomalies and bathymetric expressions, such as pockmarks, mounds, and ridges. Almost all identified seabed features are associated with bright spots and flat spots beneath, as mapped within the 3-D seismic grid. We obtained EM122 multi-beam data using closely spaced receiver beams and 4-5 times overlapping multi-beam swaths, which greatly improved the sounding density and geologic resolvability of the data. At least one location shows an acoustic plume in the water column on a 3.5 kHz profile, and this plume is located along a fault trace and above surface and subsurface seepage indicators. Fluid indicators are largely associated with folds and faults within the sediment section, and many of the faults continue into and offset the reflective basement. A dense pattern of normal faults is seen on the outer shelf in the multi-beam bathymetry, backscatter, and 3-D seismic data, and the majority of fluid seepage indicators lie along mapped fault traces. Furthermore, linear mounds, ridges, and pockmark chains are found on the upper, middle, and lower slope regions. The arcuate shape of the shelf edge, projection of the Quepos Ridge, and high density of potential seep sites suggest that this area may be a zone of former seamount/ridge subduction. These results demonstrate a much greater potential seep density and distribution than previously reported across the Costa Rican margin.Components: 12,500 words, 15 figures.Keywords: fluid seepage; fluid flow; subduction zones; Marine Geology and Geophysics; Costa Rica.Index Terms: 3060 Marine Geology and Geophysics: Subduction zone processes (1031, 3613, 8170, 8413)

In 2011 we acquired a 3D seismic reflection volume across the Costa Rica margin NW of the Osa Peninsula to investigate the complex structure and the development of the seismogenic zone within the Costa Rica subduction zone in the vicinity of recent International Ocean Drilling Program (IODP) drilling. In contrast to previous interpretations, these newly acquired seismic images show that the margin wedge is composed of a layered fabric that is consistent with clastic sediments, similar to materials recovered from IODP drilling, that have been thrust and thickened into thrust-bounded folded sequences. These structures are consistent with a balanced sequence that has been frontally accreted in the context of an accretionary model. We interpret these sequences as sediment originally deposited on the subducting crust in a trench basin created by the southward migration of the Cocos-Nazca-Caribbean triple junction, and accreted