The CAD/CAM technology associated with rapid prototyping (RP) is already widely used in the fabrication of all-ceramic fixed prostheses and in the biomedical area; however, the use of this technology for the manufacture of metal frames for removable dentures is new. This work reports the results of a literature review conducted on the use of CAD/CAM and RP in the manufacture of removable partial dentures.

No abstract

The fatigue experiment produced a pattern of failures that is very similar to that observed in clinical trials of Y-TZP crowns that are veneered with feldspathic porcelain. Crowns cemented with an adhesive resin cement exhibited chipping at a significantly higher mean load than those cemented with luting cements that do not usually form strong bonds with dentin. When cemented with adhesive resin cement, glazing or sandblasting the intaglio surface of the framework significantly reduced the mean fatigue loads at which chipping of veneers occurred, as compared to crowns whose intaglio surface had only been cleaned with alcohol. For this cement glazing or sandblasting the intaglio surface of the crown is not recommended.

No abstract

The objective of this study was to evaluate the influence of different surface agents on the flexural strength of a ceramic system. Eighty bar-shaped specimens of zirconia were divided into four groups according to the agent to be used: group Control -to be cleaned with alcohol; group VM9 -application of a fluid layer of porcelain; group Effect Bonder -application of a bonding agent; and group Coloring Liquid -application of coloring liquid. All specimens received the porcelain application by the layering technique and were then subjected to thermocycling. The four-point bending test was performed to calculate the strength values (σ, MPa) and the failure modes were classified. ANOVA did not detect significant differences among the groups. The Weibull modulus were 5 (Control, VM9 and Effect Bonder) and 6 (Coloring Liquid). The cracking of the porcelain ceramic toward the interface was the predominant failure mode. It was concluded that the surface agents tested had no effect on the flexural strength of the bilaminated ceramic specimens.