Schottky barrier photovoltaic detectors have been fabricated on n-AlxGa1−xN(0⩽x⩽0.35) and p-GaN epitaxial layers grown on sapphire. Their characteristics have been analyzed and modeled, in order to determine the physical mechanisms that limit their performance. The influence of material properties on device parameters is discussed. Our analysis considers front and back illumination and distinguishes between devices fabricated on ideal high-quality material and state-of-the-art heteroepitaxial AlxGa1−xN. In the former case, low doping levels are advisable to achieve high responsivity and a sharp spectral cutoff. The epitaxial layer should be thin (<0.5 μm) to optimize the ultraviolet/visible contrast. In present devices fabricated on heteroepitaxial AlxGa1−xN, the responsivity is limited by the diffusion length. In this case, thick AlxGa1−xN layers are advisable, because the reduction in the dislocation density results in lower leakage currents, larger diffusion length, and higher responsivity. In order to improve bandwidth and responsivity, and to achieve good ohmic contacts, a moderate n-type doping level (∼1018 cm−3) is recommended.
Polarization-sensitive photodetectors for the ultraviolet spectral range based on M-plane GaN films grown on LiAlO 2 substrates have been fabricated and characterized. These detectors exploit the dichroic properties of strained, M-plane GaN films. For a 400-nm-thick film, a maximum contrast of 7.25 between the detection of light polarized perpendicular and parallel to the c-axis is reached at 363 nm. Considerations for the detector design show that thin strained M-plane GaN films will enhance the polarization-sensitive bandwidth, while the maximum contrast can be obtained for relaxed thick films under weak signal detection conditions.
The authors demonstrate a photodetection configuration where the responsivity in the ultraviolet spectral region is limited to a few nanometers, representing high-quality-factor, narrow-band detection together with polarization sensitivity. Both features are obtained by utilizing a polarization-sensitive photodectector in combination with a polarization filter made from two identical M-plane GaN films on γ-LiAlO2 (100) substrate. The optical band gap of these films depends on the direction of the in-plane polarization vector of the incident light beam with respect to the c axis. Electronic-band-structure calculations show that the naturally present anisotropic in-plane strain in these films is the crucial parameter to achieve both a high responsivity and a high polarization contrast.
GaN:Mg/AlGaN single-heterojunction light-emitting diodes were grown on Si(111) substrates by plasma-assisted molecular-beam epitaxy. High-quality Mg-doped GaN layers with hole concentrations up to 1.2×1017 holes/cm3 and intense low-temperature photoluminescence, which increases in annealed samples, were obtained. Smooth AlGaN layers, with surface roughness below 5 nm, were used as buffer layers. Continuous-wave room-temperature ultraviolet electroluminescence was observed at 365 nm with a full width at half maximum of 8 nm. An estimated optical power output of 1.5 μW was achieved under 15 V/35 mA operation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.