In this study, a mathematical method was used to estimate the entrance surface dose (ESD) to the patient and the scattered dose (Ds) to the operating surgeon during various fluoroscopically guided surgical orthopaedic procedures. For 204 patients, the procedure type, the fluoroscopy time and the highest tube potential and current values observed during fluoroscopy were recorded. For the most often performed procedures (intramedullary nailing of peritrochanteric fractures, open reduction and internal fixation of malleolar fractures and intramedullary nailing of diaphyseal fractures of the femur), the respective mean fluoroscopy times were 3.2, 1.5 and 6.3 min while the estimated mean ESDs were 183, 21 and 331 mGy, respectively. The estimated Ds rates for the hands, chest, thyroid, eyes, gonads and legs of the operating surgeon were on average to 0.103, 0.023, 0.013, 0.012, 0.066 and 0.045 mGy min(-1), respectively, and compare well with the literature. The mathematical estimation of doses cannot replace actual measurements; however, it can be used for a preliminary assessment of the radiation dose levels during various surgical procedures, so that the operator, the surgeon and the rest of the medical staff involved could be aware of the associated radiation risk and the radiation protection measures required.

For the CT interventions studied, and especially for biopsies and radiofrequency ablations, patient effective doses were considerably high. Maximum peak absorbed dose observed was about 1 Gy, considerably lower than the threshold for deterministic effects (2 Gy).

The purpose of this investigation was to measure the dose-area product (DAP) and the other relevant dosimetric quantities in diagnostic and therapeutic endoscopic retrograde cholangiopancreatography (ERCP). Furthermore, the dependence of patient dose and image quality on the tube potential was investigated. A DAP meter was used for dose monitoring in seven diagnostic and 21 therapeutic ERCPs. For each ERCP the DAP meter readings, fluoroscopy time, number of radiographs and exposure data were recorded. From these data the fluoroscopy and radiography contributions to DAP, the entrance skin dose and the effective dose for each examination were estimated. For the investigation of the effect of tube potential on patient dose and image quality, a water phantom containing syringes filled with diluted contrast media was used. The average DAP was 13.7 Gy cm2 in diagnostic and 41.8 Gy cm2 in therapeutic ERCP whereas the average fluoroscopy times were 3.1 and 6.0 min respectively. DAP was strongly correlated to the fluoroscopy time. Measurements in the phantom showed that a good compromise between image quality and patient dose is obtained for tube potentials around 80 kV. Therapeutic ERCPs deliver on average higher doses to patients than diagnostic ERCPs. However, for a difficult diagnostic ERCP more patient exposure may be required than for a simple therapeutic ERCP.

No abstract

Even in examinations that did not exceed the DRL, patient protection can be optimised further by appropriate collimation of field size to that necessary for diagnosis.