Gel-derived titania coating on commercial pure (c.P.) titanium induces hydroxyapatite formation onto its surface from a simulated body fluid (SBF, a metastable calcium phosphate solution). The induced apatite is similar to bone apatite in that it is poorly crystallized, calcium-deficient, and carbonate-containing. Furthermore, the carbonate (Cog-) groups go into the apatite lattice and lie at the positions of PO:-and OH-to replace these ionic groups, resembling the (COi-) groups of bone apatite. Therefore, the apatite induced by the gel-derived titania is said to be bonelike. A chemical stimulation, stemming from abundant hydroxyl groups and negative charges at the surface of the titania gel, is believed to be responsible for the bonelike apatite induction. The potential of bone-bonding is predicted for the gel-derived titania, for it is an efficient bonelike apatite inducer in the SBF.

In dentistry, adhesion promotion with 3-methacryloyloxypropyltrimethoxysilane is usually sufficient, but its hydrolytic stability is a continuous concern. The hydrolytic stability of an alternative, 3-isocyanatopropyltriethoxysilane, was compared with that of conventional 3-methacryloyloxypropyltrimethoxysilane. Two silanes, both in 0.1 and 1.0 vol-% in ethanol-water, were evaluated in the attachment of an experimental bis-phenol-A-diglycidyldimethacrylate (Bis-GMA) resin to grit-blasted (with two different systems) titanium. Silane hydrolysis was monitored by FTIR spectrometry. Bis-GMA resin was applied and photo-polymerized on titanium. The specimens were thermocycled (6000 cycles, 5-55 degrees C). Surface analysis was carried out with scanning electron microscopy. Statistical analysis (ANOVA) showed that the highest shear bond was achieved with 0.1% 3-isocyanatopropyltriethoxysilane (12.5 MPa) with silica-coating, and the lowest with 1.0% 3-methacryloyloxypropyltrimethoxysilane (3.4 MPa) with alumina-coating. The silane, its concentration, and the grit-blasting method significantly affected the shear bond strength (p < 0.05). SEM images indicated cohesive failure of bonding, and, in conclusion, 3-isocyanatopropyltriethoxysilane is a potential coupling agent.

No abstract

Sol-gel-derived SiO2 and CaO-P2O5-SiO2 have been shown to be bioactive and bone bonding. In this study bioactive sol-gel-derived SiO2 and CaO-P2O5-SiO2 systems were tested for in in vitro bioactivity. The calcined ceramic monoliths were immersed in a simulated body fluid and analyzed to follow the hydroxyapatite formation on the ceramic surface. Apatite-forming ability was investigated in terms of structural changes by changing the composition and the preparation method. The role of Ca and P dopants in the substrate structure is complicated, and careful characterization is needed. The composition and structure together determine the in vitro bioactivity. The pore structure was analyzed using N2-adsorption/desorption isotherms. The results indicate that a great mesopore volume and a wide mesopore size distribution favor hydroxycarbonate apatite nucleation and a great surface area is not needed. The performed preparation process for silica in a basic environment provides a convenient way to prepare a mesoporous material.