This study examined the effect of a nightguard vital bleaching procedure on enamel surface morphology and the shear bond strength of a composite resin luting cement to enamel. Extracted human teeth were bleached for 1 week using a vital bleaching product. Control teeth were brushed with a fluoride toothpaste and processed similarly to the bleached teeth, however the bleaching product was substituted with artificial saliva in the night guards. Teeth were stored in artificial saliva for 24 h, 1, 6 or 12 weeks and then examined for any surface changes using light and scanning electron microscopy. The effect of etching surfaces with 37% phosphoric acid was examined at the scanning electron microscope level. The shear bond strength of composite resin luting cement to both buccal and lingual surfaces of bleached and control teeth was determined. Light microscopy investigation suggested the bleaching process resulted in a loss of mineral from enamel which was evident 24 h after bleaching and was sustained following 12 weeks storage in artificial saliva. Scanning electron microscopy showed a definite change in the surface texture of the bleached enamel surface. Acid etching of the bleached enamel surface produced loss of prismatic form and the enamel appeared overetched. The mean shear bond strength between composite resin luting cement and etched enamel tended to be lower for bleached enamel surfaces, however no significant difference in shear bond strength was noted between control and experimental groups. The results of this study suggest that bleaching resulted in changes to the surface and subsurface layers of enamel. Although surface changes were observed in the etched enamel, the shear bond strength of composite resin luting cement to etched bleached enamel appeared to be clinically acceptable.

With a tube etching process, conical-ended optical fibers for middle infrared lasers that have lateral emissions can be produced, a feature of benefit for delivering laser energy onto the root canal walls. This study examined the ability of these improved laser tips when Er:YAG and Er,Cr:YSGG lasers were used in root canals in which thick smear layers had been created intentionally to provide a challenge for the laser system. Smear layer was assessed from scanning electron microscopy images with an objective digital method. Lasing improved the action of ethylene diamine tetraacetic acid with cetavlon (EDTAC) in removing smear layer. Conical fibers performed better than plain fibers, but there was no difference in performance between the 2 laser systems when matched for all other parameters. These results provide a "proof of concept" for lateral emitting fibers for endodontic procedures and illustrate the novel contribution of lasing to the action of EDTAC in dissolving smear layer.

Fissure sealants have been used successfully as a means of preventing fissure caries. This effectiveness is directly related to sealant retention and retention is dependent upon a meticulous method of application. The aims of this study were to determine if sealant adhesion and penetration were affected by the variation in preparation of the enamel surface, or by pretreatment of the enamel surface with dentine adhesive systems, in fissures of varying morphology. Non-carious posterior teeth were visually examined and sorted according to fissure type, classified as shallow, deep or intermediate. Occlusal fissures were sealed using one of six methods, thermocycled for 200 cycles between 5 and 55 degrees C, in artificial saliva, then placed in a 1.5% procion orange dye for 3 min. Teeth were sectioned bucco-lingually and examined with a light microscope for (i) penetration of the sealant into the fissure pattern and (ii) adhesion of the sealant. All sealant techniques employed in this study adapted well to the enamel surface as the 1.5% procion Reactive orange dye failed to penetrate any of the sealed tooth sections. Shallow fissures were well obturated in both lateral and vertical dimensions. Sealants adapted well to the vertical walls at the orifice of deep fissures but generally failed to penetrate into the deeper aspects. Reducing the etching period with 37% phosphoric acid resulted in increased voids between the sealant and enamel surface and poorer adaptation to the vertical walls. The addition of dentine adhesive systems, Scotchbond Multi-Purpose and All-Bond 2, enhanced the vertical penetration of the sealant, particularly in deep fissures. It is proposed that the dentine adhesive systems may improve the retention rate of sealants in deep fissures particularly if the fissure is not completely dry prior to resin placement.

Analysis 4.4. Comparison 4: Risk-based versus 24 months: 4-year outcome data, Outcome 4: Probing pocket depth (mm)......... Analysis 4.5. Comparison 4: Risk-based versus 24 months: 4-year outcome data, Outcome 5: Patients OHIP-14 (0 to 56 scale where lower score is better

During the 2004 annual meeting of the International Association for Dental Research, the Education Research Group held a symposium on dental outreach teaching. After a brief introduction, which reviews relevant aspects of the relatively sparse literature, this paper summarises the proceedings, the themes and conclusions that emerged and the research issues that were identified. It aims to describe aspects of current practice around the world and to promote future discussion. Presenters gave details of outreach programmes for dental undergraduates in Australia, Finland, Malaysia (and Southeast Asia), the United Kingdom and the United States. From these presentations four themes emerged. They were: reasons for the introduction of outreach teaching, its perceived beneficial effects, organisational issues, educational issues. The reasons included a recognition of the need to educate dental undergraduates as members of 'care teams' in the environments and communities where they were ultimately like to work and the current shortage of both suitable patients and teachers (faculty) in many dental schools. A wide range of potential benefits and some disadvantages were identified. The organisational issues were, in the main, seen to relate to finance and administration. The educational issues included the need to train and monitor the performance of teachers at outreach clinics and to assess the performance of the undergraduates whilst at the outreach locations. It was concluded that new technology made it easier to teach at a distance and it was possible to create a dental 'school without walls'. It was recognised that few evaluations of dental outreach teaching have been carried out and that there were many research questions to be answered, including: whether it should be a voluntary or compulsory part of the undergraduate curriculum, how long it should last and what type of outcomes should be assessed.