We present new types of solitary wave solutions for the higher order nonlinear Schrodinger (HNLS) equation describing propagation of femtosecond light pulses in an optical fiber under certain parametric conditions. Unlike the reported solitary wave solutions of the HNLS equation, the novel ones can describe bright and dark solitary wave properties in the same expressions and their amplitude may approach nonzero when the time variable approaches infinity. In addition, such solutions cannot exist in the nonlinear Schrodinger equation. Furthermore, we investigate the stability of these solitary waves under some initial pertubations by employing the numerical simulation methods.

In this paper we present four-wave mixing (FWM) based parametric conversion experiments in p-i-n diode assisted silicon-on-insulator (SOI) nano-rib waveguides using continuous-wave (CW) light around 1550 nm wavelength. Using a reverse biased p-i-n waveguide diode we observe an increase of the wavelength conversion efficiency of more than 4.5 dB compared to low loss nano-rib waveguides without p-i-n junction, achieving a peak efficiency of -1 dB. Conversion efficiency improves also by more than 7 dB compared to previously reported experiments deploying 1.5 µm SOI waveguides with p-i-n structure. To the best of our knowledge, the observed peak conversion efficiency of -1dB is the highest CW efficiency in SOI reported so far.

Abstract:In this paper, unique surface sensing property and enhanced sensitivity in microring resonator biosensors based on subwavelength grating (SWG) waveguides are studied and demonstrated. The SWG structure consists of periodic silicon pillars in the propagation direction with a subwavelength period. Effective sensing region in the SWG microring resonator includes not only the top and side of the waveguide, but also the space between the silicon pillars on the light propagation path. It leads to greatly increased sensitivity and a unique surface sensing property in contrast to common evanescent wave sensors: the surface sensitivity remains constantly high as the surface layer thickness grows. Microring resonator biosensors based on both SWG waveguides and conventional strip waveguides were compared side by side in surface sensing experiment and the enhanced surface sensing capability in SWG based microring resonator biosensors was demonstrated. M. C. C. Estevez, M. Alvarez, and L. M. M. Lechuga, "Integrated optical devices for lab-on-a-chip biosensing applications," Laser Photon. Rev. 6, 463-487 (2012 J. Vörös, "The density and refractive index of adsorbing protein layers.," Biophys.

We experimentally demonstrate a label-free sensor based on nanoslotted parallel quadrabeam photonic crystal cavity (NPQC). The NPQC possesses both high sensitivity and high Q-factor. We achieved sensitivity (S) of 451 nm/refractive index unit and Q-factor >7000 in water at telecom wavelength range, featuring a sensor figure of merit >2000, an order of magnitude improvement over the previous photonic crystal sensors. In addition, we measured the streptavidin-biotin binding affinity and detected 10 ag/mL concentrated streptavidin in the phosphate buffered saline solution.

We present nanoscale photonic crystal sensor arrays (NPhCSAs) on monolithic substrates. The NPhCSAs can be used as an opto-fluidic architecture for performing highly parallel, label-free detection of biochemical interactions in aqueous environments. The architecture consists of arrays of lattice-shifted resonant cavities side-coupled to a single PhC waveguide. Each resonant cavity has slightly different cavity spacing and is shown to independently shift its resonant peak (a single and narrow drop) in response to the changes in refractive index. The extinction ratio of well-defined single drop exceeds 20 dB. With three-dimensional finite-difference time-domain (3D-FDTD) technique, we demonstrate that the refractive index sensitivity of 115.60 nm/RIU (refractive index unit) is achieved and a refractive index detection limit is approximately of 8.65×10-5 for this device. In addition, the sensitivity can be adjusted from 84.39 nm/RIU to 161.25 nm/RIU by changing the number of functionalized holes.