A series of tests on cold-formed steel square and rectangular hollow sections subjected to web crippling is reported in this paper. The web crippling tests were conducted under two loading conditions of end-two-flange (ETF) and interior-two-flange (ITF), which are specified in the current North American Specification for cold-formed steel structures. The concentrated load was applied by means of bearing plates, which act across the full flange width of the specimen sections. Different bearing lengths were investigated. The test specimens were fabricated by cold-rolling from steel sheet with nominal yield strength of 345MPa. The measured web slenderness values of the tubes ranged from 15.5 to 46.0. The test strengths obtained from this study are compared with the design strengths obtained using the current North American Specification, Australia Standard, European Code and Chinese Code for cold-formed steel structures. It is shown that the design strengths predicted by the specifications are either unreliable or too conservative.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.