No abstract

No abstract

This paper presents a facile hydrolysis reaction and annealing for preparing a novel hierarchical nanoheterostructure via assembly of α-FeO nanorods onto multiwall carbon nanotubes (MWCNTs) backbones. The as-synthesized nanocomposites were characterized using XRD (X-ray diffraction), FESEM (Field emission scanning electron microscopy), TEM (Transmission electron microscopy), XPS (X-ray photoelectron spectroscopy) and BET (Surface Area and Porosity System). The observations showed uniform α-FeO nanorods approximately 100-200 nm in length and 50-100 nm in diameter that were hierarchically assembled onto the surface of the MWCNTs. The formation of the heterostructure was investigated by observing the evolution of the microstructure of the products at different reaction times. The X-ray photoelectron spectra (XPS) showed that the ability of the absorbing oxygen was enhanced by the formation of the heterostructure composites. Moreover, as a proof-of-concept presentation, the novel CNTs@α-FeO hierarchical heterostructure acted as a gas sensitive material. Significantly, the composites exhibited excellent sensing properties for acetone with high sensitivity, exceptional selectivity and good reproducibility. The response of the CNTs@α-FeO sensor to 100 ppm acetones at 225 °C was nearly 35, which was superior to the single α-FeO nanorods with a response of 16, and the detection limit of the sensor was 500 ppb. The enhanced properties were mainly attributed to the unique structure and p-n heterojunction between the CNTs and the α-FeO nanorods.

This article reports on the synthesis of a series of poly(alkyl methacrylate) brush-grafted, 23 nm silica nanoparticles (hairy NPs) and the study of the effect of alkyl pendant length on their use as oil lubricant additives for friction and wear reduction. The hairy NPs were prepared by surface-initiated reversible addition-fragmentation chain transfer polymerization from trithiocarbonate chain transfer agent (CTA)-functionalized silica NPs in the presence of a free CTA. We found that hairy NPs with sufficiently long alkyl pendant groups (containing >8 carbon atoms, such as 12, 13, 16, and 18 in this study) could be readily dispersed in poly(alphaolefin) (PAO), forming clear, homogeneous dispersions, and exhibited excellent stability at low and high temperatures as revealed by visual inspection and dynamic light scattering studies. Whereas poly(n-hexyl methacrylate) hairy NPs cannot be dispersed in PAO under ambient conditions or at 80 °C, interestingly, poly(2-ethylhexyl methacrylate) hairy NPs can be dispersed in PAO at 80 °C but not at room temperature, with a reversible clear-to-cloudy transition observed upon cooling. High-contact-stress ball-on-flat reciprocating sliding tribological tests at 100 °C showed significant reductions in both the coefficient of friction (up to 38%) and wear volume (up to 90% for iron flat) for transparent, homogeneous dispersions of hairy NPs in PAO at a concentration of 1.0 wt % compared with neat PAO. The formation of a load-bearing tribofilm at the rubbing interface was confirmed using scanning electron microscopy coupled with energy-dispersive X-ray spectroscopy.