We demonstrate a controlled growth of nitrogen-doped graphene layers by liquid precursor based chemical vapor deposition (CVD) technique. Nitrogen-doped graphene was grown directly on Cu current collectors and studied for its reversible Li-ion intercalation properties. Reversible discharge capacity of N-doped graphene is almost double compared to pristine graphene due to the large number of surface defects induced due to N-doping. All the graphene films were characterized by Raman spectroscopy, transmission electron microscopy, and X-ray photoemission spectroscopy. Direct growth of active electrode material on current collector substrates makes this a feasible and efficient process for integration into current battery manufacture technology.

We report that graphene coatings do not significantly disrupt the intrinsic wetting behaviour of surfaces for which surface-water interactions are dominated by van der Waals forces. Our contact angle measurements indicate that a graphene monolayer is wetting-transparent to copper, gold or silicon, but not glass, for which the wettability is dominated by short-range chemical bonding. With increasing number of graphene layers, the contact angle of water on copper gradually transitions towards the bulk graphite value, which is reached for ~6 graphene layers. Molecular dynamics simulations and theoretical predictions confirm our measurements and indicate that graphene's wetting transparency is related to its extreme thinness. We also show a 30-40% increase in condensation heat transfer on copper, as a result of the ability of the graphene coating to suppress copper oxidation without disrupting the intrinsic wettability of the surface. Such an ability to independently tune the properties of surfaces without disrupting their wetting response could have important implications in the design of conducting, conformal and impermeable surface coatings.

No abstract

The fabrication of a mechanically flexible, piezoelectric nanocomposite material for strain sensing applications is reported. Nanocomposite material consisting of zinc oxide (ZnO) nanostructures embedded in a stable matrix of paper (cellulose fibers) is prepared by a solvothermal method. The applicability of this material as a strain sensor is demonstrated by studying its real-time current response under both static and dynamic mechanical loading. The material presented highlights a novel approach to introduce flexibility into strain sensors by embedding crystalline piezoelectric material in a flexible cellulose-based secondary matrix.

Water flow over carbon nanotubes has been shown to generate an induced voltage in the flow direction due to coupling of ions present in water with free charge carriers in the nanotubes. However, the induced voltages are typically of the order of a few millivolts, too small for significant power generation. Here we perform tests involving water flow with various molarities of hydrochloric acid (HCl) over few-layered graphene and report order of magnitude higher induced voltages for graphene as compared to nanotubes. The power generated by the flow of ∼0.6 M HCl solution at ∼0.01 m/sec was measured to be ∼85 nW for a ∼30 × 16 μm size graphene film, which equates to a power per unit area of ∼175 W/m(2). Molecular dynamics simulations indicate that the power generation is primarily caused by a net drift velocity of adsorbed Cl(-) ions on the continuous graphene film surface.