Four human subjects undergoing subdural electrocorticography for epilepsy surgery engaged in a range of finger and hand movements. We observed that the amplitudes of the low-pass filtered electrocorticogram (ECoG), also known as the local motor potential (LMP), over specific peri-Rolandic electrodes were correlated (p < 0.001) with the position of individual fingers as the subjects engaged in slow and deliberate grasping motions. A generalized linear model (GLM) of the LMP amplitudes from those electrodes yielded predictions for positions of the fingers that had a strong congruence with the actual finger positions (correlation coefficient, r; median = 0.51, maximum = 0.91), during displacements of up to 10 cm at the fingertips. For all the subjects, decoding filters trained on data from any given session were remarkably robust in their prediction performance across multiple sessions and days, and were invariant with respect to changes in wrist angle, elbow flexion and hand placement across these sessions (median r = 0.52, maximum r = 0.86). Furthermore, a reasonable prediction accuracy for grasp aperture was achievable with as few as three electrodes in all subjects (median r = 0.49; maximum r = 0.90). These results provide further evidence for the feasibility of robust and practical ECoG-based control of finger movements in upper extremity prosthetics.

No abstract

In patients with unilateral upper limb paralysis from strokes and other brain lesions, strategies for functional recovery may eventually include brain-machine interfaces (BMIs) using control signals from residual sensorimotor systems in the damaged hemisphere. When voluntary movements of the contralateral limb are not possible due to brain pathology, initial training of such a BMI may require use of the unaffected ipsilateral limb. We conducted an offline investigation of the feasibility of decoding ipsilateral upper limb movements from electrocorticographic (ECoG) recordings in three patients with different lesions of sensorimotor systems associated with upper limb control. We found that the first principal component (PC) of unconstrained, naturalistic reaching movements of the upper limb could be decoded from ipsilateral ECoG using a linear model. ECoG signal features yielding the best decoding accuracy were different across subjects. Performance saturated with very few input features. Decoding performances of 0.77, 0.73, and 0.66 (median Pearson's r between the predicted and actual first PC of movement using nine signal features) were achieved in the three subjects. The performance achieved here with small numbers of electrodes and computationally simple decoding algorithms suggests that it may be possible to control a BMI using ECoG recorded from damaged sensorimotor brain systems.

One of the most exciting and compelling areas of research and development is building brain-machine interfaces (BMIs) for controlling prosthetic limbs. Prosthetic limb technology is advancing rapidly, and the Johns Hopkins University/Applied Physics Lab (JHU/APL) Modular Prosthetic Limb (MPL) permits actuation with 17 degrees of freedom in 26 articulating joints. There are many signals from the brain that can be leveraged, including the spiking rates of neurons in the cortex, electrocorticographic (ECoG) signals from the surface of the cortex, and electroencephalographic (EEG) signals from the scalp. Unlike microelectrodes which record spikes, ECoG does not penetrate the cortex and also has higher spatial specificity, signal-to-noise ratio, and bandwidth than EEG signals. We have implemented an ECoG-based system for controlling the MPL in the Johns Hopkins Hospital Epilepsy Monitoring Unit, where patients are implanted with ECoG electrode grids for clinical seizure mapping and asked to perform various recorded finger or grasp movements. We have shown that low frequency local motor potentials and ECoG power in the high gamma frequency (70–150 Hz) range correlates well with grasping parameters and they stand out as good candidate features for closed-loop control of the MPL.