No abstract

To cite this article: Ahmad Jabari Kohpaei , Arumugam Sathasivan & Hanieh Aboutalebi (2011) Effectiveness of parallel second order model over second and first order models, Desalination and Water Treatment, 32:1-3, 107-114To link to this article: http://dx. ab s t r ac tThe chlorine decay is usually described by the first order model (FOM) due to its easiness, although its weaknesses are well known. In this work, two better models, second order model (SOM) and parallel second order model (PSOM), are compared for their accuracy to predict chlorine residuals for a single dosing scenario. Results showed that SOM model provided a better prediction compared to FOM. However, SOM had two important shortcomings. Firstly, it overly predicted residuals in the lower end of chlorine decay curve, implying false sense of security in achieving secondary disinfection goals. Secondly, when higher initial dose was practiced, chlorine residual prediction was poorer. PSOM on the other hand provided the best fit for the experimental data in the initial as well as the later part of the decay curve for any doses. Compared to SOM which had two parameters, PSOM is more complex as it uses four parameters. Comparing to the advantages, complexity of PSOM is not an issue as EPANET-MSX can be used for full scale system simulation.

To cite this article: Ahmad Jabari Kohpaei , Arumugam Sathasivan & Hanieh Aboutalebi (2011) Evaluation of second order and parallel second order approaches to model temperature variation in chlorine decay modelling, Desalination and Water Treatment, 32:1-3, 100-106To link to this article: http://dx. ab s t r ac tAll drinking water receives some form of disinfection and a minimum residual should remain at the customer's tap. Most popular disinfectant of all is chlorine. Chlorine reacts with compounds in water and hence leads to decay. Temperature is one of the important factors that control the rate of decay. Annual water temperature variations of more than 20°C are common in distribution systems, so that dosing needs to be adjusted substantially between seasons to maintain residuals within desired limits. Arrhenius equation has been successfully used to estimate the temperature effects on chlorine decay reactions, especially when temperature is below 30°C. The temperature dependence parameter estimated is activation energy (E)/universal gas constant (R). A number of chlorine decay tests were conducted, by varying temperature from 15-50°C. Resulting chlorine measurements were input into AQUASIM, data fitting was performed using the parallel second order model (PSOM) proposed by Kastl et al.[1] and second order model (SOM) proposed by Clark [2]. The model parameters for all modelling approaches were estimated using AQUASIM. PSOM has two reactants and two respective decay coefficients. Results showed that PSOM fitted the data very well when either single or two E/Rs were used. On the contrary, the SOM did not show a good fit to the experimental chlorine decay profile for the same data sets. The results, therefore, indicated PSOM is more convenient to describe chlorine decay profile over a wide range of temperature.

No abstract