No abstract

No abstract

The great advancement in the development of carbide cutting tool with super-hard coating layers taken place in recent few decades, can improve the performance of cutting tool and machinability of titanium alloy. The turning parameters evaluated are cutting speed (55, 75, 95 m/min), feed rate (0.15, 0.25, 0.35 mm/rev), depth of cut (0.10, 0.15, 0.20 mm) and tool grade of PVD carbide tool. The results that tool life shows patterns of rapidly increase at the initial stage and gradually increased at the second stage and extremely increased at the final stage. The trend lines of surface roughness have are the surface roughness value is high at first machining after that regularly decreases. Work hardening of the deformed layer beneath machined surface caused higher hardness than the average hardness of the base material. However, the softening effect also occurred below the machined surface. Segmentation or serration at the chip edge was caused by high strain and pressure during machining.

Wear mechanism on the flank of a cutting tool is caused by friction between newly machined surface and the cutting tool, which plays predominant role in determining tool life. Detailed study on wear mechanism at the cutting edge of carbide tools were carried out at cutting speed of 55 – 95 m/min, feed rate of 0.15 – 0.35 mm/rev and depth of cut of 0.10 – 0.20 mm. The wear on the cutting tools was occurred predominantly on the nose radius, as effect of lower feedrate and nose radius selected. Various wear observed on both coated and uncoated cutting tool such as abrasive wear, adhesive wear, adhering chip on the cutting edge, flaking, chipping, coating delamination of coated tool, crack and fracture. The abrasive wear predominantly occurred on the flank face while the flaking on the rake face. Abrasive wear occurred at nose radius due to the depth of cut selected was low therefore, the contact area between the cutting tool and the workpiece material was small. Adhesion or welded titanium alloy onto the flank and rake faces demonstrated a strong bond at the workpiece-tool interface. The adhesion wear takes place after the coating has worn out or coating delamination has been occurred. The crack occurred possibly due to machining at high cutting speed and high depth of cut. Cutting at high cutting speed caused more heat generated at the cutting edge and at high depth of cut caused more cutting forces on the insert.

Inconel 718 has found its niche in many industries, owing to its unique properties such as high oxidation resistance and corrosion resistance even at very high temperatures. Coated carbide tool with hard layer of PVD TiAlN is used to turn Inconel 718. Taguchi method with the orthogonal array L 9 is applied in this experiment with the parameter cutting speed of 60-80 m/min, feed rate of 0.2-0.3 mm/rev, and depth of cut of 0.3-0.5 mm. The results show that depth of cut is a significant influence to the tool life. Cutting speed of 60 m/min, feed rate of 0.2 mm/rev, and depth of cut of 0.3 mm are the optimum parameters. The flank wear, crater wear, notch wear, and nose wear are the wear mechanisms on the carbide tool. Through the SEM, abrasion, attrition, and adhesion are the wear mechanisms which can be seen on the cutting tool.