Transition-metal oxides with the perovskite structure are promising catalysts to promote the kinetics of the oxygen evolution reaction (OER). To improve the activity and stability of these catalysts, a deeper understanding about the active site, the underlying reaction mechanism, and possible side reactions is necessary. We chose smooth epitaxial (100)-oriented La 0.6 Sr 0.4 MnO 3 (LSMO) films grown on Nb:SrTiO 3 (STNO) as a model electrode to investigate OER activity and stability using the rotating ring−disk electrode (RRDE) method. Careful electrochemical characterization of various films in the thickness range between 10 and 200 nm yields an OER activity of the epitaxial LSMO surface of 100 μA/cm 2 ox at 1.65 V vs RHE, which is among the highest reported for LSMO and close to (110)-oriented IrO 2 . Detailed post-mortem analysis using XPS, XRD, and AFM revealed the high structural and morphological stability of LSMO after OER. The observed correlation between activity and Mn vacancies on the surface suggested Mn as the active site for the OER in (100)-oriented LSMO, in contrast to similar perovskite manganites, such as Pr 1−x Ca x MnO 3 . The observed Tafel slope of about 60 mV/dec matches the theoretical prediction for a chemical ratelimiting step that follows an electrochemical pre-equilibrium, probably O−O bond formation. Our study established LSMO as an atomically flat oxide with high intrinsic activity and high stability.

Experimental studies of the electronic structure of excess electrons in liquids—archetypal quantum solutes—have been largely restricted to very dilute electron concentrations. We overcame this limitation by applying soft x-ray photoelectron spectroscopy to characterize excess electrons originating from steadily increasing amounts of alkali metals dissolved in refrigerated liquid ammonia microjets. As concentration rises, a narrow peak at ~2 electron volts, corresponding to vertical photodetachment of localized solvated electrons and dielectrons, transforms continuously into a band with a sharp Fermi edge accompanied by a plasmon peak, characteristic of delocalized metallic electrons. Through our experimental approach combined with ab initio calculations of localized electrons and dielectrons, we obtain a clear picture of the energetics and density of states of the ammoniated electrons over the gradual transition from dilute blue electrolytes to concentrated bronze metallic solutions.

Real time in-situ microscopy imaging of surface structure and atom dynamics of heterogeneous catalysts is an important step for understanding reaction mechanisms. Here, using in-situ environmental transmission electron microscopy (ETEM), we directly visualize surface atom dynamics at manganite perovskite catalyst surfaces for oxygen evolution reaction (OER), which are ≥20 times faster in water than in other ambients. Comparing (001) surfaces of La0.6Sr0.4MnO3 and Pr0.67Ca0.33MnO3 with similar initial manganese valence state and OER activity, but very different OER stability, allows us to distinguish between reversible surface adatom dynamics and irreversible surface defect chemical reactions. We observe enhanced reversible manganese adatom dynamics due to partial solvation in adsorbed water for the highly active and stable La0.6Sr0.4MnO3 system, suggesting that aspects of homogeneous catalysis must be included for understanding the OER mechanism in heterogeneous catalysis.

Improving the activity of catalysts for the oxygen evolution reaction (OER) requires a detailed understanding of the surface chemistry and structure to deduce structure-function relationships (descriptors) for fundamental insight. We chose epitaxial (100)-oriented La 0.6 Sr 0.4 Mn 1−δ O 3 (LSMO) thin films as a model system with high electrochemical activity comparable to (110)-oriented IrO 2 to investigate the effect of Mn off-stoichiometry on both catalytic activity and stability. Extensive structural characterization was performed by microscopic and spectroscopic methods before and after electrochemical characterization using rotating ring-disk studies. Stoichiometric LSMO had the highest activity, while both Mn deficiency and excess reduced the catalytic activity. Furthermore, all samples preserved the crystal structure up to the very surface. Mn excess improved the long-term activity, and we hypothesize that excess Mn stabilizes the surface chemistry during catalysis. Our data show that the defect chemistry should be considered when designing catalysts with enhanced activity and rugged stability.