The carrier collection efficiency (ηc) and energy conversion efficiency (ηe) of polymer photovoltaic cells were improved by blending of the semiconducting polymer with C60 or its functionalized derivatives. Composite films of poly(2-methoxy-5-(2'-ethyl-hexyloxy)-1,4-phenylene vinylene) (MEH-PPV) and fullerenes exhibit ηc of about 29 percent of electrons per photon and ηe of about 2.9 percent, efficiencies that are better by more than two orders of magnitude than those that have been achieved with devices made with pure MEH-PPV. The efficient charge separation results from photoinduced electron transfer from the MEH-PPV (as donor) to C60 (as acceptor); the high collection efficiency results from a bicontinuous network of internal donor-acceptor heterojunctions.

Evidence for photoinduced electron transfer from the excited state of a conducting polymer onto buckminsterfullerene, C(60), is reported. After photo-excitation of the conjugated polymer with light of energy greater than the pi-pi* gap, an electron transfer to the C(60) molecule is initiated. Photoinduced optical absorption studies demonstrate a different excitation spectrum for the composite as compared to the separate components, consistent with photo-excited charge transfer. A photoinduced electron spin resonance signal exhibits signatures of both the conducting polymer cation and the C(60) anion. Because the photoluminescence in the conducting polymer is quenched by interaction with C(60), the data imply that charge transfer from the excited state occurs on a picosecond time scale. The charge-separated state in composite films is metastable at low temperatures.

We have developed a transparent organic polymeric material that can repeatedly mend or "re-mend" itself under mild conditions. The material is a tough solid at room temperature and below with mechanical properties equaling those of commercial epoxy resins. At temperatures above 120 degrees C, approximately 30% (as determined by solid-state nuclear magnetic resonance spectroscopy) of "intermonomer" linkages disconnect but then reconnect upon cooling, This process is fully reversible and can be used to restore a fractured part of the polymer multiple times, and it does not require additional ingredients such as a catalyst, additional monomer, or special surface treatment of the fractured interface.

No abstract

The fluorescence of a polyanionic conjugated polymer can be quenched by extremely low concentrations of cationic electron acceptors in aqueous solutions. We report a greater than millionfold amplification of the sensitivity to fluorescence quenching compared with corresponding ''molecular excited states.'' Using a combination of steady-state and ultrafast spectroscopy, we have established that the dramatic quenching results from weak complex formation [polymer (؊) ͞quencher (؉) ], followed by ultrafast electron transfer from excitations on the entire polymer chain to the quencher, with a time constant of 650 fs. Because of the weak complex formation, the quenching can be selectively reversed by using a quencher-recognition diad. We have constructed such a diad and demonstrate that the fluorescence is fully recovered on binding between the recognition site and a specific analyte protein. In both solutions and thin films, this reversible fluorescence quenching provides the basis for a new class of highly sensitive biological and chemical sensors. With the rising awareness of the public vulnerability to chemical and biological terrorism, there is a heightened need for detection techniques that show both high sensitivity and selectivity. Such techniques also would find wide use in medical diagnostics and biomedical research applications. Methods of identifying biological molecules such as the enzyme-linked immunosorbant assay (ELISA) achieve selectivity by using specific antibody͞antigen interactions to anchor the antigen to a substrate, with a subsequent colorimetric change or fluorescence signal on addition of secondary reagents; these techniques can be time-consuming and require multistep procedures. Other approaches have used molecular recognition ligands to link to specific receptor sites on a biological species, usually as a means also of fixing the biomolecule to a substrate or membrane (1-6) It has remained a challenge to incorporate the selectivity offered by ligand͞receptor interactions into a sensor that can be extremely sensitive, robust, and versatile.We have recently explored the photophysical properties of a fluorescent, water-soluble polyanionic conjugated polymer [poly (2-methoxy-5-propyloxy sulfonate phenylene vinylene (MPS-PPV)] (Fig. 1B), one of a larger class of related molecules [poly phenylene vinylene (PPV)] (Fig. 1 A and derivatives) that has been the subject of almost explosive recent interest (7-13). Although much attention has focused on the well known potential for use of PPV derivatives as electronic materials [e.g., electrochemical sensors (14-16) light-emitting diodes (17, 18), and integrated circuits (19,20)], the highly charged backbone of MPS-PPV (with charge density approximating that of polynucleic acids such as DNA and RNA), also makes it a model polymer for understanding the interactions and self-assembly properties of charged biopolymers. In this paper, we report a striking discovery: the use of this fluorescent anionic polymer leads to a greater than million-fold amplificatio...