SUMMARYElectric energy storage systems are used considerably in industries and daily applications. The demand for batteries with high energy content has increased because of their use in hybrid vehicles. Lead-acid batteries have wide applications because of their advantages such as high safety factor and low cost of production. The major shortcoming of lead-acid batteries is low energy content and high dimension and weight. Nowadays, a common method to increase the energy content of lead-acid battery is the experimental method with trial and error, which is time consuming and expensive. In this paper, non-isothermal one-dimensional numerical simulation of lead-acid battery with finite volume method is performed. In addition, a cell with higher energy content and lower thickness is designed by using particle swarm optimization algorithm based on developed simulation code. The results of single objective optimization show that an optimal battery that has 27.6% higher energy can be made with the same cell dimension. The results also show that an optimum cell battery can be obtained with a decrease of 24% in thickness while keeping the energy the same. Moreover, a multi-objective optimization algorithm is utilized to find Pareto optimal solutions while considering the energy content and thickness objectives simultaneously.
Wind turbines are of the most promising devices to cut down carbon emissions. However, some phenomena that adversely affect their performance are inevitable. The aim of the present paper is to investigate flow separation prevention exploiting leading edge (LE) single dielectric barrier discharge plasma actuator (SDBD-PA) on an airfoil belonging to a section of a locally developed wind turbine. The numerical results of the surface pressure distribution over the airfoil were compared with the experimental measurements carried out by the authors on the same blade section, and good agreement was found between numerical and experimental data for both plasma-OFF and plasma-ON cases. An in-depth parametric numerical investigation was then carried out to provide a better understanding of the flow behavior affected by the activation of PA over the same airfoil at post stall angle of attacks (AOAs). According to the results, the frequency and voltage of actuation, AOA, and free stream velocity are shown to have strong impacts on separation delay and actuation effectiveness. In Reynolds number of 2.85 × 105, the maximum PA effectiveness takes place at 21° which is approximately 312%, 307%, and 256% corresponding to the PA location of LE, 0.02 chord, and 0.15 chord, respectively. Also, maximum velocity of the domain is increased three times of the free stream velocity on average for three investigated Reynolds numbers at the frequency and voltage of 12 kHz and 12 kV, respectively. Furthermore, the size of the wake area noticeably contracts due to the presence of the SDBD-PA. The results clearly indicate that the lift and drag coefficients as well as the lift-to-drag ratio fit a linear variation pattern with the frequency of actuation. The variation rate of the aforementioned parameters becomes steeper as the peak voltage of actuation increases. Highly nonlinear aerodynamic responses and significant interactions were demonstrated between the investigated parameters.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.