Among the factors of production, irrigation and nitrogen fertilization are essential for increasing productivity and quality of green corn. The objective was to identify the ideal amount of water and nitrogen dose for the development of green corn. For this, an experiment was carried out at the Federal University of Alagoas, Campus Arapiraca, using a randomized block design in a split plot scheme, with five irrigation depths and five nitrogen doses. In the plots the irrigation depths were determined based on the evapotranspiration of the crop (0, 50, 100, 150 and 200% of the crop evapotranspiration, ETc). And, in the subplots, the nitrogen doses (0, 50, 100, 150 and 200% of the recommendation for the cultivation of corn). The morphological variables were analyzed: plant height and stem diameter and physiological variables: chlorophyll and chlorophyll content a and b. The corn culture did not respond to the nitrogen doses applied for any variable analyzed. For the morphological variables, the highest plant height (2.46 m) was obtained by applying 160% of the irrigation depth; the largest stem diameter (26 mm) was obtained in the 200% ETC blade. For the physiological variables, the highest chlorophyll content was obtained in the smallest slide tested; while for chlorophyll a and b, the increase of one unit in the percentage of ETc, increased by 1.3 and 0.3 mg m-2, respectively for these variables. The culture of green corn is sensitive to water deficit, responding satisfactorily to strata above 100% of the ETc.
RESUMO O milho verde é uma cultura que desperta interesse por ser uma alternativa de grande valor econômico e seu cultivo irrigado associado à adequada densidade de semeadura tem papel importante em seu rendimento. Objetivou-se avaliar a produtividade do milho verde em função de lâminas de irrigação e densidades de semeadura. A pesquisa foi conduzida na área experimental da Universidade Federal de Alagoas (UFAL)-Campus de Arapiraca, no período de 18 de abril a 17 julho de 2016. Adotou-se o delineamento em blocos casualizados, em um esquema de parcelas subdivididas 5 x 5 x 3. Nas parcelas foram distribuídas as lâminas de irrigação (0; 50; 100; 150 e 200% da Evapotranspiração da cultura-ETc) e nas subparcela, as densidades de semeadura (83,3; 62,5; 50; 41,6 e 35,7 mil plantas ha-1). Ao final do ciclo foram avaliadas as variáveis: diâmetro da espiga com palha (D.E.C.P), diâmetro da espiga sem palha (D.E.S.P), comprimento da espiga com palha (C.E.C.P), comprimento da espiga sem palha (C.E.S.P), produtividade da espiga com palha (P.E.C.P) e produtividade da espiga sem palha (P.E.S.P). A densidade de semeadura proporcionou incremento para as variáveis C.E.C.P e C.E.S.P, obtendo os maiores valores na densidade de 41,6 plantas ha-1. As maiores lâminas de irrigação testadas (150 e 200%) proporcionaram os maiores incrementos para a cultura do milho verde. A cultura do milho verde obteve a maior produtividade nos maiores níveis de irrigação, assim como nas maiores densidades de semeadura. Palavras-chave: Zea mays L, manejo de água, espaçamento de cultivo, rendimento.
O cultivo de milho verde é uma atividade que vem despertando interesse por ser uma alternativa de grande valor econômico, principalmente para pequenos e médios produtores. A irrigação proporciona aos produtores demanda o ano todo e agregação de renda. Entretanto, a água vem se tornando um recurso escasso e é preciso estudos que traga orientações para o seu uso racional. A densidade de semeadura é uma das técnicas de manejo mais estudas no milho uma vez que tem papel importante no rendimento de uma lavoura. Este trabalho teve por objetivo avaliar o desempenho do milho verde submetido a diferentes lâminas de irrigação e densidades de semeadura. O experimento foi conduzido na área experimental da Universidade Federal de Alagoas (UFAL) – Campus de Arapiraca, AL. Utilizou-se o delineamento experimental em blocos casualizados, em um esquema de parcelas subdivididas 5 x 5, sendo três blocos, cinco lâminas de irrigação (0; 50; 100; 150 e 200% da ETc.) e cinco densidades de semeadura (83,3; 62,5; 50; 41,6 e 35,7 mil plantas/ha-1). Após a colheita foram avaliadas as seguintes variáveis: diâmetro da espiga com palha (D.E.C.P), diâmetro da espiga sem palha (D.E.S.P), peso fresco da espiga com palha (P.F.E.C.P), peso fresco da espiga sem palha (P.F.E.S.P), comprimento da espiga com palha (C.E.C.P), comprimento da espiga sem palha (C.E.S.P), produtividade da espiga com palha (P.E.C.P) e produtividade da espiga sem palha (P.E.S.P). Os dados foram submetidos à análise de variância aplicando-se o teste de Tukey (p<0,05) para comparação das médias entre os blocos e regressão linear e polinomial para os fatores lâmina de irrigação, densidades de semeadura e suas interações. Verificou-se que não houve efeito significativo para a interação dos fatores lâminas de irrigação e densidades de semeadura. A densidade de semeadura proporcionou incremento para as variáveis comprimento da espiga com palha (C.E.C.P) e sem palha (C.E.S.P) e produtividade da espiga com palha (P.E.C.P) e sem palha (P.E.S.P) obtendo os maiores valores na densidade de 41,6 plantas/ha-1 para os comprimentos e na densidade 83,3 plantas/ha-1 para as produtividades. As lâminas de irrigação só não influenciaram significativamente para variável comprimento da espiga com palha (C.E.C.P), obtendo os maiores valores nas maiores lâminas para as demais variáveis.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.