This paper describes the results of a study examining the flow and acoustic characteristics of an axisymmetric supersonic jet issuing from a sonic and a Mach 1.5 converging-diverging (C-D) nozzle and impinging on a ground plane. Emphasis is placed on the Mach 1.5 nozzle with the sonic nozzle used mainly for comparison. A large-diameter circular plate was attached at the nozzle exit to measure the forces generated on the plate owing to jet impingement. The experimental results described in this paper include lift loss, particle image velocimetry (PIV) and acoustic measurements. Suckdown forces as high as 60% of the primary jet thrust were measured when the ground plane was very close to the jet exit. The PIV measurements were used to explain the increase in suckdown forces due to high entrainment velocities. The self-sustained oscillatory frequencies of the impinging jet were predicted using a feedback loop that uses the measured convection velocities of the large-scale coherent vortical structures in the jet shear layer. Nearfield acoustic measurements indicate that the presence of the ground plane increases the overall sound pressure levels (OASPL) by approximately 8 dB relative to a corresponding free jet. For moderately underexpanded jets, the influence of the shock cells on the important flow features was found to be negligible except for close proximity of the ground plane.

No abstract

No abstract

A detailed experimental study of supersonic, Mach 2, flow over a three-dimensional cavity was conducted using shadowgraph visualization, unsteady surface pressure measurements, and particle image velocimetry. Large-scale structures in the cavity shear layer and visible disturbances inside the cavity were clearly observed. A large recirculation zone and high-speed reverse flow was revealed in the cavity. In addition, supersonic microjets were used at the leading edge to suppress flow unsteadiness within the cavity. With a minimal mass flux (blowing coefficient B c 0:0015), the activation of microjets led to reductions of up to 20 dB in the amplitudes of cavity tones and of more than 9 dB in the overall sound pressure levels. The microjet injection also modified the cavity mixing layer and resulted in a significant reduction in the flow unsteadiness inside the cavity as revealed by the shadowgraphs and the velocity-field measurements.

New data are presented on the structure of fin-induced, swept shock/boundary-layer interactions. These data are obtained using a nonintrusive planar laser scattering (PLS) imaging technique. A range of interaction strengths, from barely separated to very strongly separated, is covered for freestream Mach numbers of 3 and 4. These new data, when combined with previous results on the flowfield and interaction "footprint," are sufficient to allow the construction of a physical model for the swept interaction flowfield structure and behavior. This physical model is presented and discussed in terms of six detailed flowfield maps which take advantage of the inherent quasiconical behavior of the class of interactions considered.