This study addresses the development and Hardware-in-the-Loop (HiL) testing of an explicit nonlinear model predictive controller (eNMPC) for an anti-lock braking system (ABS) for passenger cars, actuated through an electro-hydraulic braking (EHB) unit. The control structure includes a compensation strategy to guard against performance degradation due to actuation dead times, identified through experimental tests. The eNMPC is run on an automotive rapid control prototyping unit, which shows its real-time capability with comfortable margin. A validated high-fidelity vehicle simulation model is used for the assessment of the ABS on a HiL rig equipped with the braking system hardware. The eNMPC is tested in 7 emergency braking scenarios, and its performance is benchmarked against a proportional integral derivative (PID) controller. The eNMPC results show: i) the control system robustness with respect to variations of tire-road friction condition and initial vehicle speed; and ii) a consistent and significant improvement of the stopping distance and wheel slip reference tracking, with respect to the vehicle with the PID ABS.

Abstract:The main benefits of dual clutch transmissions (DCTs) are: (i) a higher energy efficiency than automatic transmission systems with torque converters; and (ii) the capability to fill the torque gap during gear shifts to allow seamless longitudinal acceleration profiles. Therefore, DCTs are viable alternatives to automated manual transmissions (AMTs). For vehicles equipped with engines that can generate considerable torque, large clutch-slip energy losses occur during power-on gear shifts and, as a result, DCTs need wet clutches for effective heat dissipation. This requirement substantially reduces DCT efficiency because of the churning and ancillary power dissipations associated with the wet clutch pack. To the knowledge of the authors, this study is the first to analyse the detailed power loss contributions of a DCT with wet clutches, and their relative significance along a set of driving cycles. Based on these results, a novel hybridised AMT (HAMT) with a single dry clutch and an electric motor is proposed for the same vehicle. The HAMT architecture combines the high mechanical efficiency typical of AMTs with a single dry clutch, with the torque-fill capability and operational flexibility allowed by the electric motor. The measured efficiency maps of a case study DCT and HAMT are compared. This is then complemented by the analysis of the respective fuel consumption along the driving cycles, which is simulated with an experimentally validated vehicle model. In its internal combustion engine mode, the HAMT reduces fuel consumption by >9% with respect to the DCT.

No abstract

Abstract-Because of the introduction of progressively more restrictive regulations that aim to reduce fuel consumption and CO2 emissions, the automotive industry is focusing its efforts on environmentally friendly passenger cars. In particular, different electrification roadmaps are pursued by the individual car makers, and electrified drivetrain layouts are progressively introduced into the market. This process involves all vehicle segments, including high performance passenger cars. In this context, this study presents a novel hybridized automated manual transmission (HAMT) for cars with high power characteristics. The HAMT includes six gear ratios associated with the internal combustion engine, and two gear ratios associated with an electric motor. The energy efficiency of the HAMT is measured on a drivetrain test rig, and compared with that of an equivalent dual clutch transmission (DCT). Simulation results based on the experimentally measured efficiency maps show the significant energy consumption reduction of the HAMT in its internal combustion engine mode, with respect to the DCT.