Stove performance, characteristics, and quantities of gaseous and particulate emissions were determined for two different pellet stoves, varying fuel load, pellet diameter, and chimney draft. This approach aimed at covering variations in emissions from stoves in use today. The extensive measurement campaign included CO, NO x , organic gaseous carbon, volatile organic compounds (VOCs), polycyclic aromatic hydrocarbons (PAHs), total particulate matter (PMtot) as well as particle mass and number concentrations, size distributions, and inorganic composition. At high load, most emissions were similar. For stove B, operating at high residual oxygen and solely with primary air, the emissions of PMtot and particle numbers were higher while the particles were smaller. Lowering the fuel load, the emissions of CO and hydrocarbons increased dramatically for stove A, which operated continuously also at lower fuel loads. On the other hand for stove B, which had intermittent operation at lower fuel loads, the emissions of hydrocarbons increased only slightly lowering the fuel load, while CO emissions increased sharply, due to high emissions at the end of the combustion cycle. Beside methane, dominating VOCs were ethene, acetylene, and benzene and the emissions of VOC varied in the range 1.1−42 mg/MJfuel. PAH emissions (2−340 μg/MJfuel) were generally dominated by phenanthrene, fluoranthene and pyrene. The PMtot values (15−45 mg/MJfuel) were in all cases dominated by fine particles with mass median diameters in the range 100−200 nm, peak mobility diameters of 50−85 nm, and number concentrations in the range 4 × 1013 to 3 × 1014 particles/MJfuel. During high load conditions, the particulate matter was totally dominated by inorganic particles at 15−25 mg/MJfuel consisting of potassium, sodium, sulfur, and chlorine, in the form of K2SO4, K3Na(SO4)2, and KCl. The study shows that differences in operation and modulation principles for the tested pellet stoves, relevant for appliances in use today, will affect the performance and emissions significantly, although with lower scattering in the present study compared to compiled literature data.

The characteristics and quantities of a large number of gaseous and particulate emission components during combustion in a residential wood log stove with variations in fuel, appliance and operational conditions were determined experimentally. The measurement campaign included CO, NO x , organic gaseous carbon (OGC), volatile organic compounds (VOCs), polycyclic aromatic hydrocarbons (PAHs), total particulate matter (PMtot) as well as particle mass and number concentrations, size distributions, and inorganic composition. CO varied in the range of 1100 to 7200 mg/MJfuel, while OGC varied from 210 to 3300 mg/MJfuel. Dominating VOCs were methane, followed by ethene, acetylene, and benzene. Methane varied from 9 to 1600 mg/MJfuel. The nonmethane volatile organic compound (NMVOC) emissions were in the range of 20−2300 mg/MJfuel. The PAHtot emissions varied from 1.3 to 220 mg/MJfuel, in most cases dominated by phenantrene, fluoranthene, and pyrene. PMtot were in all cases dominated by fine particles and varied in the range 38−350 mg/MJfuel. The mass median particle diameters and the peak mobility diameters of the fine particles varied in the range 200−320 and 220−330 nm, respectively, and number concentrations in the range of 1−4 × 1013 particles/MJfuel. Air starved conditions, at high firing intensity, gave the highest emissions, especially for hydrocarbons. This type of condition is seldom considered, though it may occur occasionally. The emissions from Swedish wood stoves, comparing a Swedish field study, are covered fairly well with the applied methodology, but other field studies report considerably higher emissions especially for diluted particle sampling.

Time-resolved emissions of particulate polycyclic aromatic hydrocarbons (PAHs) and total organic particulate matter (OA) from a wood log stove and an adjusted pellet stove were investigated with high-resolution time-of-flight aerosol mass spectrometry (AMS). The highest OA emissions were found during the addition of log wood on glowing embers, that is, slow burning pyrolysis conditions. These emissions contained about 1% PAHs (of OA). The highest PAH emissions were found during fast burning under hot air starved combustion conditions, in both stoves. In the latter case, PAHs contributed up to 40% of OA, likely due to thermal degradation of other condensable species. The distribution of PAHs was also shifted toward larger molecules in these emissions. AMS signals attributed to PAHs were found at molecular weights up to 600 Da. The vacuum aerodynamic size distribution was found to be bimodal with a smaller mode (Dva ∼ 200 nm) dominating under hot air starved combustion and a larger sized mode dominating under slow burning pyrolysis (Dva ∼ 600 nm). Simultaneous reduction of PAHs, OA and total particulate matter from residential biomass combustion may prove to be a challenge for environmental legislation efforts as these classes of emissions are elevated at different combustion conditions.

BackgroundSmoke from combustion of biomass fuels is a major risk factor for respiratory disease, but the underlying mechanisms are poorly understood. The aim of this study was to determine whether exposure to wood smoke from incomplete combustion would elicit airway inflammation in humans.MethodsFourteen healthy subjects underwent controlled exposures on two separate occasions to filtered air and wood smoke from incomplete combustion with PM1 concentration at 314 μg/m3 for 3 h in a chamber. Bronchoscopy with bronchial wash (BW), bronchoalveolar lavage (BAL) and endobronchial mucosal biopsies was performed after 24 h. Differential cell counts and soluble components were analyzed, with biopsies stained for inflammatory markers using immunohistochemistry. In parallel experiments, the toxicity of the particulate matter (PM) generated during the chamber exposures was investigated in vitro using the RAW264.7 macrophage cell line.ResultsSignificant reductions in macrophage, neutrophil and lymphocyte numbers were observed in BW (p < 0.01, <0.05, <0.05, respectively) following the wood smoke exposure, with a reduction in lymphocytes numbers in BAL fluid (<0.01. This unexpected cellular response was accompanied by decreased levels of sICAM-1, MPO and MMP-9 (p < 0.05, <0.05 and <0.01). In contrast, significant increases in submucosal and epithelial CD3+ cells, epithelial CD8+ cells and submucosal mast cells (p < 0.01, <0.05, <0.05 and <0.05, respectively), were observed after wood smoke exposure. The in vitro data demonstrated that wood smoke particles generated under these incomplete combustion conditions induced cell death and DNA damage, with only minor inflammatory responses.ConclusionsShort-term exposure to sooty PAH rich wood smoke did not induce an acute neutrophilic inflammation, a classic hallmark of air pollution exposure in humans. While minor proinflammatory lymphocytic and mast cells effects were observed in the bronchial biopsies, significant reductions in BW and BAL cells and soluble components were noted. This unexpected observation, combined with the in vitro data, suggests that wood smoke particles from incomplete combustion could be potentially cytotoxic. Additional research is required to establish the mechanism of this dramatic reduction in airway leukocytes and to clarify how this acute response contributes to the adverse health effects attributed to wood smoke exposure.Trial registrationNCT01488500Electronic supplementary materialThe online version of this article (doi:10.1186/s12989-015-0111-7) contains supplementary material, which is available to authorized users.

No abstract