In chloroethene-contaminated sites undergoing in situ bioremediation, groundwater acidification is a frequent problem in the source zone, and buffering strategies have to be implemented to maintain the pH in the neutral range. An alternative to conventional soluble buffers is silicate mineral particles as a long-term source of alkalinity. In previous studies, the buffering potentials of these minerals have been evaluated based on abiotic dissolution tests and geochemical modeling. In the present study, the buffering potentials of four silicate minerals (andradite, diopside, fayalite, and forsterite) were tested in batch cultures amended with tetrachloroethene (PCE) and inoculated with different organohalide-respiring consortia. Another objective of this study was to determine the influence of pH on the different steps of PCE dechlorination. The consortia showed significant differences in sensitivities toward acidic pH for the different dechlorination steps. Molecular analysis indicated that Dehalococcoides spp. that were present in all consortia were the most pH-sensitive organohalide-respiring guild members compared to Sulfurospirillum spp. and Dehalobacter spp. In batch cultures with silicate mineral particles as pH-buffering agents, all four minerals tested were able to maintain the pH in the appropriate range for reductive dechlorination of chloroethenes. However, complete dechlorination to ethene was observed only with forsterite, diopside, and fayalite. Dissolution of andradite increased the redox potential and did not allow dechlorination. With forsterite, diopside, and fayalite, dechlorination to ethene was observed but at much lower rates for the last two dechlorination steps than with the positive control. This indicated an inhibition effect of silicate minerals and/or their dissolution products on reductive dechlorination of cis-dichloroethene and vinyl chloride. Hence, despite the proven pH-buffering potential of silicate minerals, compatibility with the bacterial community involved in in situ bioremediation has to be carefully evaluated prior to their use for pH control at a specific site.
Accurate control of groundwater pH is of critical importance for in situ biological treatment of chlorinated solvents. This study evaluated a novel approach for buffering subsurface pH that relies on the use of silicate minerals as a long-term source of alkalinity. A screening methodology based on thermodynamic considerations and numerical simulations was developed to rank silicate minerals according to their buffering efficiency. A geochemical model including the main microbial processes driving groundwater acidification and silicate mineral dissolution was developed. Kinetic and thermodynamic data for silicate minerals dissolution were compiled. Results indicated that eight minerals (nepheline, fayalite, glaucophane, lizardite, grossular, almandine, cordierite and andradite) could potentially be used as buffering agents for the case considered. A sensitivity analysis was conducted to identify the dominant model parameters and processes. This showed that accurate characterization of mineral kinetic rate constants and solubility are crucial for reliable prediction of the acid-neutralizing capacity. In addition, the model can be used as a design tool to estimate the amount of mineral (total mass and specific surface area) required in field applications.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.