No abstract

The widespread distribution of the common dandelion, that is,Taraxacum officinale, along with its ability to tolerate a wide range of environmental conditions, makes this plant a good candidate as biological monitor of environmental metal contamination.Taraxacum officinaleleaves growing spontaneously in meadows and along the streets are traditionally picked up and eaten in Italy as salad, so it is important to know the concentrations of potentially toxic elements contained in them from the point of view of food safety. For these reasons the concentrations of Cd, Cr, Cu, Fe, Mn, Pb, and Zn were determined in dandelion leaf and underlying soil samples collected at 12 sites in the province of Cuneo (Piedmont, Italy) in the vicinity of streets or roundabouts. The concentrations were compared with reference values for plant and soils and with maximum allowable concentrations in edible vegetables. Neither dandelion nor soil samples were found to be polluted by metals, but the comparison with limits for vegetables suggests that caution should be used in consuming spontaneously growing vegetables.

No abstract

In this work, a two-step sequential extraction scheme for the determination of trace elements in Arctic PM10 samples was optimized by using two certified reference materials (CRMs). By means of an experimental design for qualitative variables, the five most common extracting solutions for particulate matter (PM) sequential extraction (high purity water (HPW), 0.032 M HNO3, 0.022 M HCl, 0.11 M CH3COOH, and 0.012 M CH3COOH/CH3COONH4 buffer) and two different extraction methods (stirring and ultrasounds) were compared. The purpose of the study was the identification of the procedure which gives the best estimation of the anthropogenic portion of the elements present in PM10 samples. The use of ultrasounds instead of stirring induced a low but significant decrease of the extraction of all the elements and a decrease in the repeatability of the procedure. Diluted HNO3 was the extractant which allowed to maximize the extraction of anthropogenic elements (As, Cd, Pb, Zn) with respect to crustal ones (Al, Si, Ti). The optimized procedure proved successful in avoiding contaminations and, therefore, suitable to be applied to PM samples having extremely low concentrations, such as samples collected in polar or other remote areas. The chosen procedure was applied to ten Arctic PM10 samples, allowing for a better identification of their sources. Indeed, it was possible to hypothesize that even though the concentrations of As, Cd, K, Mg, Mn, and Ni in spring and summer were different, their mobility and, therefore, their chemical form in the analyzed PM10 samples were probably similar.