This study evaluates the effect of phosphoric acid etching of enamel margins on the microleakage of a simplified all-in-one and a self-etching adhesive system in comparison to a conventional total-etch system.
SUMMARYSixty buccal Class V cavities with beveled enamel margins were made at the cemento-enamel junction of extracted human premolars and randomly divided into five groups of 12 specimens. Clearfil SE bond was applied to Group 1; Group 2 had 35% phosphoric acid etching of the enamel margins plus Clearfil SE Bond; Group 3 was administered iBond; Group 4 had 35% phosphoric acid etching of the enamel margins plus iBond and Scotchbond Multi-Purpose was used on Group 5. All the groups were restored with a resin composite. After 24 hours of storage in 100% humidity, the samples were thermocycled, immersed in a dye solution and sectioned buccolingually and microleakage of the enamel margins was evaluated on a scale of 0 to 2. Differences among Groups 3 and 4 and Groups 3 and 5 were significant (p<0.05); however, no statistically significant differences were found between the other groups (p>0.05). The current study shows that simplified all-in-one adhesive systems need
In this laboratory study shear bond strengths of three filled and one unfilled adhesive systems to enamel and dentine were compared. Forty-eight extracted intact noncarious human mandibular molars were randomly assigned to two groups of 24 one for bonding to enamel and the other for bonding to dentine. Buccal and lingual surfaces of each tooth were randomly assigned for application of each one of filled (Prime & Bond NT (PBNT), Optibond Solo Plus (OBSP), and Clearfil SE Bond (CSEB)) and unfilled (Single Bond (SB)) adhesive systems (n = 12). A universal resin composite was placed into the translucent plastic cylinders (3 mm in diameter and 2 mm in length) and seated against the enamel and dentine surfaces and polymerized for 40 seconds. Shear bond strength was determined using a universal testing machine, and the results were statistically analyzed using two-way ANOVA, one-way ANOVA, t-test, and Tukey HSD post hoc test with a 5% level of significance.There were no statistically significant differences in bond strength between the adhesive systems in enamel, but CSEB and SB exhibited significantly higher and lower bond strength to dentine, respectively, than the other tested adhesive systems while there were no statistically significant differences between PBNT and OBSP.
Amelogenesis imperfecta (AI) has been defined as a group of hereditary enamel defects. It can be characterized by enamel hypoplasia, hypomaturation, or hypocalcification of the teeth. AI may be associated with some other dental and skeletal developmental defects. Restoration for patients with this condition should be oriented toward the functional and esthetic rehabilitation. This clinical report describes the oral rehabilitation of a young patient diagnosed with the hypoplastic type of AI in posterior teeth and hypomatured type of AI in anterior teeth.
This case report describes fabrication of a palatal lift prosthesis for a quadriplegic edentulous 30-year-old male with past head traumatic injury. We constructed an implant supported bar and used a soft-lining material for the maxillary palatal lift prosthesis to minimize the possibility of implant overloading and also provide a less complex and less expensive procedure for this patient.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.