This letter reports the field emission measurements from the nanotubes of aluminum nitride which were synthesized by gas phase condensation using the solid-vapor equilibria. A dc arc plasma reactor was used for producing the vapors of aluminum in a reactive nitrogen atmosphere. Nanoparticles and nanotubes of aluminum nitride were first characterized by transmission electron microscope and tube dimensions were found to be varying from 30 to 200 nm in diameter and 500 to 700 nm in length. These tubes were mixed with nanoparticles of size range between 5 and 200 nm in diameter. Tungsten tips coated with these nanoparticles and tubes were used as a field emitter. The field emission patterns display very interesting features consisting of sharp rings which were often found to change their shapes. The patterns are attributed to the open ended nanotubes of aluminum nitride. A few dot patterns corresponding to the nanoparticles were also seen to occur. The Fowler-Nordheim plots were seen to be nonlinear in nature, which reflects the semi-insulating behavior of the emitter. The field enhancement factor is estimated to be 34 500 indicating that the field enhancement due to the nanometric size of the emitter is an important cause for the observed emission.

Field emission studies are reported for the first time on layered MoS₂ sheets at the base pressure of ∼1 × 10⁻⁸ mbar. The turn-on field required to draw a field emission current density of 10 μA/cm² is found to be 3.5 V/μm for MoS₂ sheets. The turn-on values are found to be significantly lower than the reported MoS₂ nanoflowers, graphene, and carbon nanotube-based field emitters due to the high field enhancement factor (∼1138) associated with nanometric sharp edges of MoS₂ sheet emitter surface. The emission current-time plots show good stability over a period of 3 h. Owing to the low turn-on field and planar (sheetlike) structure, the MoS₂ could be utilized for future vacuum microelectronics/nanoelectronic and flat panel display applications.

We report here the field emission studies of a layered WS2-RGO composite at the base pressure of ~1 × 10−8 mbar. The turn on field required to draw a field emission current density of 1 μA/cm2 is found to be 3.5, 2.3 and 2 V/μm for WS2, RGO and the WS2-RGO composite respectively. The enhanced field emission behavior observed for the WS2-RGO nanocomposite is attributed to a high field enhancement factor of 2978, which is associated with the surface protrusions of the single-to-few layer thick sheets of the nanocomposite. The highest current density of ~800 μA/cm2 is drawn at an applied field of 4.1 V/μm from a few layers of the WS2-RGO nanocomposite. Furthermore, first-principles density functional calculations suggest that the enhanced field emission may also be due to an overalp of the electronic structures of WS2 and RGO, where graphene-like states are dumped in the region of the WS2 fundamental gap.

Field emission studies have been carried out on undoped as well as N- and B-doped graphene samples prepared by arc-discharge method in a hydrogen atmosphere. These graphene samples exhibit very low turn-on fields. N-doped graphene shows the lowest turn-on field of 0.6 V/μm, corresponding to emission current density of 10 μA/cm2. These characteristics are superior to the other types of nanomaterials reported in the literature. Furthermore, emission currents are stable over the period of more than 3 h for the graphene samples. The observed emission behavior has been explained on the basis of nanometric features of graphene and resonance tunneling phenomenon.

No abstract