This paper presents pool boiling data at atmospheric pressure for mechanically polished and chemically etched 304 stainless-steel surfaces in contact with distilled water. The surfaces were prepared by these techniques to produce variation in nucleation sites. Surface roughness was varied from 2–61 rms. The results show the changes in heat transfer with varying rms surface roughness and preparation technique. The Rohsenow pool boiling correlation was used to discuss the data.

No abstract

No abstract

No abstract

The present study focused on the development of NiMoAl-based self-lubricating composites using solid lubricants as the second phase by powder metallurgy. For this, Cr2AlC MAX phase, Cr2AlC–Ag, and MoS2 powders were mixed with the NiMoAl-based matrix and subsequently hot pressed to produce bulk composite samples. The average hardness and wear resistance of the matrix were found to be increased with the addition of MoS2, Cr2AlC MAX phase, and Cr2AlC–Ag powder to the NiMoAl matrix. The addition of Cr2AlC to NiMoAl was more effective in improving the wear resistance than MoS2. The addition of Cr2AlC and Cr2AlC–Ag has increased the hardness by about 75% than that with the addition of NiMoAl alloy. A scanning Kelvin probe system was used to study the surface properties of the tribofilm in detail through work function mapping from the edge area to the wear area (groove). Among all the samples, the one with the addition of Cr2AlC–Ag powder to the NiMoAl matrix possesses the best tribo-mechanical properties. Cr2AlC–Ag composite addition to NiMoAl was found to decrease the wear rate by one-third and to reduce the coefficient of friction by one-fourth, compared to the base NiMoAl alloy. This was attributed to the high-sintered density and formation of strong tribofilms consisting of mixed oxides such as Ag2MoO4 and Al2O3, as confirmed by micro Raman spectra.