We characterize inductors fabricated from ultra-thin, approximately 100 nm wide strips of niobium (Nb) and niobium nitride (NbN). These nanowires have a large kinetic inductance in the superconducting state. The kinetic inductance scales linearly with the nanowire length, with a typical value of 1 nH µm(-1) for NbN and 44 pH µm(-1) for Nb at a temperature of 2.5 K. We measure the temperature and current dependence of the kinetic inductance and compare our results to theoretical predictions. We also simulate the self-resonant frequencies of these nanowires in a compact meander geometry. These nanowire inductive elements have applications in a variety of microwave frequency superconducting circuits.

Detecting spatial and temporal information of individual photons by using singlephoton-detector (SPD) arrays is critical to applications in spectroscopy, communication, biological imaging, astronomical observation, and quantum-information processing. Among the current SPDs 1 , detectors based on superconducting nanowires have outstanding performance 2 , but are limited in their ability to be integrated into large scale arrays due to the engineering difficulty of high-bandwidth cryogenic electronic readout [3][4][5][6][7][8] . Here, we address this problem by demonstrating a scalable single-photon imager using a single continuous photon-sensitive superconducting nanowire microwave-plasmon transmission line. By appropriately designing the nanowire's local electromagnetic environment so that the nanowire guides microwave plasmons, the propagating voltages signals generated by a photon-detection event were slowed down to ~ 2% of the speed of light. As a result, the time difference between arrivals of the signals at the two 2 ends of the nanowire naturally encoded the position and time of absorption of the photon. Thus, with only two readout lines, we demonstrated that a 19.7-mm-long nanowire meandered across an area of 286 μm × 193 μm was capable of resolving ~ 590 effective pixels while simultaneously recording the arrival times of photons with a temporal resolution of 50 ps. The nanowire imager presents a scalable approach to realizing high-resolution photon imaging in time and space. Main Text:Quantum and classical optics are currently limited by our ability to efficiently sense and process information about single photons. For example, to enhance the information-carrying capacity of a quantum channel 9 and improve security in quantum key distribution 10,11 , information is typically encoded in the position and arrival time of individual photons.Determining the spatial and temporal information of photons is currently accomplished by single-photon detector (SPD) arrays. Among existing SPD array technologies, the transition edge sensor (TES) and the microwave kinetic inductance detector (MKID) provide moderate spectral information but less impressive temporal resolution (e.g., the timing jitter is measured in nanoseconds for TESs 12 and microseconds for MKIDs 13 ). Photomultiplier tubes and singlephoton avalanche diodes have sub-1-ns timing jitter in the visible domain, but their detection performance deteriorates in the infrared, and scaling these technologies to large spatial arrays is challenging 1 . Improved timing performance of sub-20-ps timing jitter 14 and sub-10-ns recovery time 15 is possible with superconducting-nanowire single-photon detectors (SNSPDs), which also have been demonstrated to have near-unity detection efficiency 2 , less than 1 dark-count per second (cps) 16 , a wide spectral response from the visible to infrared 17 and greater than 100 cps 3 counting rate 18 . However, attempts to create arrays of SNSPDs have had limited success 3-8 .Traditional row-column rectangular pixel arra...

We study the reset dynamics of niobium ��Nb�� superconducting nanowire single-photon detectors ��SNSPDs�� using experimental measurements and numerical simulations. The numerical simulations of the detection dynamics agree well with experimental measurements, using independently determined parameters in the simulations. We find that if the photon-induced hotspot cools too slowly, the device will latch into a dc resistive state. To avoid latching, the time for the hotspot to cool must be short compared to the inductive time constant that governs the resetting of the current in the device after hotspot formation. From simulations of the energy relaxation process, we find that the hotspot cooling time is determined primarily by the temperature-dependent electron-phonon inelastic time. Latching prevents reset and precludes subsequent photon detection. Fast resetting to the superconducting state is, therefore, essential, and we demonstrate experimentally how this is achieved. We compare our results to studies of reset and latching in niobium nitride SNSPDs

We study the microwave impedance of extremely high aspect ratio (length/width ≈ 5,000) superconducting niobium nitride nanowires. The nanowires are fabricated in a compact meander geometry that is in series with the center conductor of a 50  coplanar waveguide transmission line. The transmission coefficient of the sample is measured up to 20 GHz. At high frequency, a peak in the transmission coefficient is seen. Numerical simulations show that this is a half-wave resonance along the length of the nanowire, where the nanowire acts as a high impedance, slow wave transmission line. This resonance sets the upper frequency limit for these nanowires as inductive elements. Fitting simulations to the measured resonance enables a precise determination of the nanowire's complex sheet impedance at the resonance frequency. The real part is a measure of dissipation, while the imaginary part is dominated by kinetic inductance. We characterize the dependence of the sheet resistance and sheet inductance on both temperature and current and compare the results to recent theoretical predictions for disordered superconductors. These results can aid in the understanding of high frequency devices based on superconducting nanowires. They may also lead to the development of novel superconducting devices such as ultra-compact resonators and slowwave structures.2

We report on the detection of single photons with λ = 8 µm using a superconducting hotelectron microbolometer. The sensing element is a titanium transition-edge sensor with a volume ~ 0.1 µm 3 fabricated on a silicon substrate. Poisson photon counting statistics including simultaneous detection of 3 photons was observed. The width of the photon-number peaks was 0.11 eV, 70% of the photon energy, at 50-100 mK. This achieved energy resolution is one of the best figures reported so far for superconducting devices. Such devices can be suitable for singlephoton calorimetric spectroscopy throughout the mid-infrared and even the far-infrared.