Background: In orthodontic therapy, the enamel around brackets is very susceptible to bacterial-plaque retention, which represents a risk factor for dental tissues. The aim of this study was to evaluate the effect of methylene blue and a chlorophyllin–phycocyanin mixture, used with and without light activation, in contrast with a 2% chlorhexidine solution, on Streptococcus mutans colonies. Methods: Twenty caries-free human extracted teeth were randomized into five groups. A Streptococcus mutans suspension was inoculated on teeth in groups B, C, D, and E (A was the positive-control group). Bacterial colonies from groups C, D, and E (B was the negative-control group) were subjected to photosensitizers and 2% chlorhexidine solution. For groups C and D, a combined therapy consisting of photosensitizer and light activation was performed. The Streptococcus mutans colonies were counted, and smears were examined with an optical microscope. Two methods of statistical analysis, unidirectional analysis of variance and the Tukey–Kramer test, were used to evaluate the results. Results: A statistically significant reduction in bacterial colonies was detected after the combined therapy was applied for groups C and D, but the most marked bacterial reduction was observed for group D, where a laser-activated chlorophyll–phycocyanin mixture was used. Conclusions: Photodynamic therapy in combination with methylene blue or chlorophyllin–phycocyanin mixture sensitizers induces a statistically significant decrease in the number of bacterial colonies.

(1) Background: The prevention of demineralizing lesions at the enamel structure level continues to represent a challenge in daily dental practice. When bacteria influence the pH level, this will decrease below the threshold for remineralization and the dissociation of hydroxyapatite will occur with a high percentage of phosphate and calcium loss. These elements continue to be studied by many authors in order to obtain a working protocol that will lead to their stabilization at the level of the enamel structure, thus preventing the demineralization process. The aim of this study is to evaluate and compare the influence of two types of laser wavelengths on the surface morphology and mineral components of the enamel through an examination with scanning electron microscopy (SEM) and energy-dispersive X-ray spectrometry (EDX). (2) Methods: Thirty permanent human incisors extracted for periodontal reasons from patients aged 25–40 years old were selected for this study. Metallic brackets (SS Standard 022 Slot, OC Orthodontics, McMinnville, OR, 97128, USA) were bonded onto each tooth. The buccal surface was randomly assigned three sections: Section A—negative control (no treatment), section B—treated with 980 nm Gallium–Aluminum–Arsenide diode laser (a 300 µm optic fiber was used with 0.8 W output power, energy density of 5.33 J/mm2, in continuous mode, for 30 s, oriented perpendicularly to the enamel surface in contact mode) (KaVo GENTLEray 980 Diode Laser, Kaltenbach & Voigt GmbH, Biberach, Germany), and section C—treated with Nd:YAG laser (a 300 µm fiber was carried out at a 1 mm distance from the enamel surface with 0.75 W power, 75 mJ pulse energy, pulse repetition rate of 10 Hz, 5 J/mm2 fluency, average exposure time of 30 s, and water cooling assisted) (LIGHTWALKER AT S, M021-5AF/1 S, Fotona d.o.o, Ljubljana, Slovenia). The elements evaluated in this study were calcium (Ca), phosphate (P), oxygen (O), and carbon (C). A one-way analysis of variance, paired t-tests, and independent t-tests were carried out to evaluate the results using the SPSS 19 IBM Statistical package software for Microsoft. (3) Results: The evaluation of the data indicated that both wavelengths produced an increase in Ca wt% (for diode laser the mean of Ca wt% before irradiation was 21.06, while that after treatment reached 28.24; and for Nd:YAG laser, the mean of Ca wt% before irradiation was 21.31, while that after treatment reached 33.88); as well, the 980 nm diode laser decreased P wt% (from 17.20 before irradiation to 16.92 after irradiation) and the Nd:YAG laser increased P wt% (from 17.46 before irradiation to 18.28 after irradiation). These results showed a statistically significant difference at the p < 0.05 level. (4) Conclusions: It can be concluded that the best improvement of enamel chemical composition was obtained with Nd:YAG irradiation.

In orthodontic practice, due to the increased interest among patients in smile aesthetics, different types of brackets are now being used, with those most frequently applied being ones made of polycrystalline and monocrystalline ceramic. The aim of this study was to evaluate the laser Er:YAG-assisted debonding technique compared to conventional methods for removing monocrystalline ceramic brackets from human teeth. The study sample included 60 vital teeth (frontals of the upper jaw) from 10 patients who had monocrystalline ceramic brackets and were in the final phase of orthodontic treatment. The debonding procedure was carried out following a split-mouth study design, using either the conventional technique or laser Er:YAG 2940 nm radiation. For each tooth, three variables were evaluated: the patient’s sujective tooth sensitivity associated with the debonding, the time required for debonding, and pulp blood flow microdynamics after the debonding. Three evaluation instruments were used to assess and quantify the treatment effects: (i) the Wong–Baker FACES Pain Rating Scale for pain assessment; (ii) a digital stopwatch/timer to measure the time required to remove the bracket; and (iii) laser Doppler flowmetry (LDF) for recording the pulp blood flow evolution. The statistical analysis of the recorded data showed a statistically significant difference between the two debonding methods regarding the tooth sensitivity during the debonding and the time required for the procedure. The subjective tooth sensitivity was reduced from a mean ± standard deviation of 3.07 ± 1.46 to 0.47 ± 0.86 on the Wong–Baker FACES scale (Wilcoxon signed rank, p < 0.001). The necessary time for debonding was reduced by 0.697 ± 0.703 s per tooth (paired t-test, p < 0.001). There was no difference in the blood microdynamics between the two debonding techniques. According to the results of this study, the laser Er:YAG-assisted debonding technique may be a viable alternative to the conventional method for monocrystalline ceramic brackets.

The heat produced during tooth preparation could be a source of damage for dental pulp, and many variables are involved in this process. The aim of this in vitro study was to evaluate whether the different degrees of wear of the diamond burs significantly influenced the temperature changes in the pulp chamber during tangential veneer preparation. The sample comprised 30 intact permanent monoradicular teeth, randomly assigned to three study groups of 10 teeth each, of which 5 had the pulp tissue preserved and 5 had thermoconductive paste in the pulp chamber. For prosthetic preparation, we used new burs in the first group, burs at their fifth use in the second group, and burs at their eighth use for the third group. The pulp chamber temperature was evaluated at the start, after one minute, and after three minutes of preparation, using a k-type thermocouple. The results of the three-way ANOVA and Tukey post hoc comparisons showed a highly significant effect of the time of measurement, while the pulp condition and the degree of wear of the burs had no effect. In conclusion, the different degrees of wear of conventional diamond burs do not produce statistically significant different changes in the pulp chamber temperature.