This work presents a review on the effect of transverse mode instability in high-power fiber laser systems and the corresponding investigations led worldwide over the past decade. This paper includes a description of the experimental observations and the physical origin of this effect, as well as some of the proposed mitigation strategies.

A new way of stabilizing the output beam of a fiber laser system operating above the mode instability threshold is described and the first proof-of-principle experimental results are presented. This technique, which relies on a modulation of the pump power, works by washing the thermally-induced refractive index grating out, which weakens the coupling efficiency between transverse modes. One of the main advantages of this simple, yet powerful, approach is that it can be easily incorporated in already existing fiber laser systems since it does not require any additional optical elements. Using this beam stabilization strategy, a significant pointing stability and beam quality improvement has been demonstrated up to an average power of ~600W, which is a factor of 2 above the mode instability threshold.

The effect of transverse mode instability (TMI) is currently the main limitation for the further average-power scaling of fiber laser systems with diffraction-limited beam quality. In this work a main driving force for TMI in fiber amplifiers is identified. Our experiments and simulations illustrate that the performance of fiber laser systems in terms of their diffraction-limited output power can be significantly reduced when the pump or seed radiation exhibit intensity noise. This finding emphasizes the fact that the TMI threshold is not only determined by the active fiber but, rather, by the whole system. In the experiment an artificially applied pump intensity-noise of 2.9% led to a reduction of the TMI threshold of 63%, whereas a similar seed intensitynoise decreased it by just 13%. Thus, even though both noise sources have an impact on the TMI threshold, the pump intensity-noise can be considered as the main driver for TMI in saturated fiber amplifiers. Additionally, the work unveils that the physical origin of this behavior is linked to the noise transfer function in saturated fiber amplifiers. With the gained knowledge and the experimental and theoretical results, it can be concluded that a suppression of pump-noise frequencies below 20 kHz could strongly increase the TMI threshold in high-power fiber laser systems.

Thermally induced refractive index gratings in Yb-doped fibers lead to transverse mode instability (TMI) above an average power threshold, which represents a severe problem for many applications. To obtain a deeper understanding of TMI, the evolution of the strength of the thermally induced refractive index grating with the average output power in a fiber amplifier is experimentally investigated for the first time. This investigation is performed by introducing a phase shift between the refractive index grating and modal interference pattern, which is obtained by applying a pump power variation to the fiber amplifier. It is demonstrated that the refractive index grating is sufficiently strong to enable modal energy coupling at powers that are significantly below the TMI threshold if the induced phase shift is sufficiently large. The experiments indicate that at higher powers, the refractive index grating becomes more sensitive to such phase shifts, which will ultimately trigger TMI. Furthermore, the experimental results demonstrate beam cleaning above the TMI threshold via the introduction of a positive phase shift. This finding paves the way for the development of a new class of mitigation strategies for TMI that are based on controlling the phase shift between the thermally induced refractive index grating and modal interference pattern.