A high degree of gait symmetry is characteristic of healthy gait. The aim of this study is to examine the symmetry of various gait parameters in subjects with unilateral trans-tibial amputation over a range of acceptable anteroposterior translational and tilt alignments, and further to examine if a consistent alignment of highest symmetry can be found. Acceptable alignments were determined by bench, static and dynamic testing on level and non-level surfaces. A total of 15 kinetic and kinematic parameters were then measured in the seven subjects participating in this study. Results indicate that some parameters show consistently higher symmetries, particularly the vertical ground reaction force parameters and the stance duration, step length and time to full knee flexion during the swing phase. Symmetries in other parameters such as knee flexion at loading response, acceleration impulse, and peak anteroposterior propulsive force seem to have little relevance in determining whether the gait pattern for that prosthetic alignment is acceptable or not. While analysis of the symmetry of more relevant gait parameters may assist the prosthetist in consistently and objectively identifying a most symmetrical alignment within the acceptable range, further clinical study is required before any conclusions can be drawn regarding evaluation of symmetry as a tool in defining any optimum alignment.
Abstract-When taking molds for foot orthoses, it is accepted practice to position the subtalar joint in its neutral position. However, foot orthoses have no contact with the talus, and this leads to a hypothesis that as long as there is correction available to appropriately align the forefoot relative to the hindfoot when taking a mold, changes in subtalar joint angles do not lead to significant alterations in the plantar surface shapes of the molds taken. This study tested this presumption with 20 subjects between 22 and 46 years old. During non-weightbearing casting, the subtalar joints were aligned at positions of 4° of eversion, 2° of eversion, 2° of inversion, and in neutral. At each orientation, forces were applied over the forefoot such that the metatarsal heads were aligned with the rearfoot. Digital scanning was used to analyze the shape of each negative mold. There were significant changes in projection volume in different subtalar joint orientations. However, the changes in arch heights, navicular height, and protrusion were insignificant and very small. It is therefore suggested that as long as the forefoot and hindfoot are appropriately aligned, variations in the orientation of the subtalar joint would be acceptable.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.