No abstract

Material extrusion additive manufacturing of metal (metal MEX), which is one of the 3D printing processes, has gained more interests because of its simplicity and economics. Metal MEX process is similar to the conventional metal injection moulding (MIM) process, consisting of feedstock preparation of metal powder and polymer binders, layer-by-layer 3D printing (metal MEX) or injection (MIM) to create green parts, debinding to remove the binders and sintering to create the consolidated metallic parts. Due to the recent rapid development of metal MEX, it is important to review current research work on this topic to further understand the critical process parameters and the related physical and mechanical properties of metal MEX parts relevant to further studies and real applications. In this review, the available literature is systematically summarised and concluded in terms of feedstock, printing, debinding and sintering. The processing-related physical and mechanical properties, i.e., solid loading vs. dimensional shrinkage maps, sintering temperature vs. relative sintered density maps, stress vs. elongation maps for the three main alloys (316L stainless steel, 17-4PH stainless steel and Ti-6Al-4V), are also discussed and compared with well-established MIM properties and MIM international standards to assess the current stage of metal MEX development.

No abstract

Purpose The purpose of this paper is to systematically investigate the influence of build orientation on the anisotropic as-printed and as-sintered bending properties of 17-4PH stainless steel fabricated by metal fused filament fabrication (MFFF). Design/methodology/approach The bending properties of 17-4PH alloy fabricated by low-cost additive manufacturing (MFFF) using three build orientations (the Flat, On-edge and Upright orientations) are examined at both as-printed and as-sintered states. Findings Unlike tensile testing where the Flat and On-edge orientations provide similar as-sintered tensile properties, the On-edge orientation produces a significantly higher bending strain with a lower bending strength than the Flat orientation. This arises from the printed layer sliding due to the Poisson's effect, which is only observed in the On-edge orientation together with the alternated layers of highly deformed and shifted voids. The bending properties show that the Upright orientation exhibits the lowest bending properties and limited plasticity due to the layer delamination. Originality/value This study is the first work to study the effect of build orientation on the flexural properties for MFFF. This work gives insight information into anisotropy in flexural mode for MFFF part design.

No abstract